ICS501A
LOCO™ PLL CLOCK MULTIPLIER CLOCK MULTIPLIER
IDT®
LOCO™ PLL CLOCK MULTIPLIER 4
ICS501A REV H 113011
DC Electrical Characteristics
VDD=3.3 V ±10% , Ambient temperature -40 to +85° C, unless stated otherwise
AC Electrical Characteristics
VDD = 3.3 V ±10%, Ambient Temperature -40 to +85° C, unless stated otherwise
Note 1: Measured with 15 pF load.
Parameter Symbol Conditions Min. Typ. Max. Units
Operating Voltage VDD 3.0 3.6 V
Input High Voltage, ICLK only V
IH
ICLK (pin 1) (VDD/2)+1 V
Input Low Voltage, ICLK only V
IL
ICLK (pin 1) (VDD/2)-1 V
Input High Voltage V
IH
OE (pin 7) 2.0 V
Input Low Voltage V
IL
OE (pin 7) 0.8 V
Input High Voltage V
IH
S0, S1 VDD-0.5 V
Input Low Voltage V
IL
S0, S1 0.5 V
Output High Voltage V
OH
I
OH
= -12 mA 2.4 V
Output Low Voltage V
OL
I
OL
= 12 mA 0.4 V
IDD Operating Supply Current, 20 No load, 100M 20 mA
Short Circuit Current CLK output +
70 mA
On-Chip Pull-up Resistor Pin 7 270 kΩ
Input Capacitance, S1, S0, and OE Pins 4, 6, 7 4 pF
Nominal Output Impedance 20 Ω
Parameter Symbol Conditions Min. Typ. Max. Units
Input Frequency, crystal input F
IN
see page 2 27 MHz
Input Frequency, clock input F
IN
see page 2 50 MHz
Output Frequency, VDD = 3.0 to 3.6 V F
OUT
0° C to +70° C200MHz
-40° C to +85° C166MHz
Output Clock Rise Time t
OR
0.8 to 2.0 V, Note 1 1 ns
Output Clock Fall Time t
OF
2.0 to 8.0 V, Note 1 1 ns
Output Clock Duty Cycle t
OD
1.5 V, up to 160
MHz
45 49-51 55 %
PLL Bandwidth 120 kHz
Output Enable Time, OE high to
output on
50 ns
Output Disable Time, OE low to
tri-state
50 ns
Absolute Clock Period Jitter t
ja
Deviation from mean
+70 ps
One Sigma Clock Period Jitter t
js
25 ps
