EVERLIGHT ELECTRONICS CO., LTD.
Technical Data Sheet
Top View LEDs
65-21-B3P-U6R2S2A7C-2T8-AM
Everlight Electronics Co., Ltd. http://www.everlight.com Page:
14 of 15
Device No.:
DSE-0001914
(B) Recommend soldering pad
Note: Tolerances unless mentioned ±0.1mm. Unit = mm
2. Current limiting
A resistor should be used to limit current spikes that can be caused by voltage fluctuations.
Otherwise damage could occur.
3. Storage
3.1 Moisture proof bag should only be opened immediately prior to usage.
3.2 Environment should be less than 30℃ and 60% RH when moisture proof bag is opened.
3.3 After opening the package MSL Conditions stated on page 1 of this spec should not be
exceeded.
3.4 If the moisture sensitivity card indicates higher than acceptable moisture, the component
should be baked at min. 60deg +/-5deg for 24 hours.
4. Iron Soldering
Hand soldering is not recommended for regular production. These guidelines are for rework only.
Soldering iron tip should contact each terminal no more than 3 sec at 350℃, using soldering iron
with nominal power less than 25W. Allow min. 2 sec. between soldering intervals.
5. Usage
Do not exceed the values given in this specification.
Application Restrictions
High reliability applications such as military/aerospace, automotive safety/security systems,
and medical equipment may require different product. If you have any concerns, please contact
Everlight before using this product in your application. This specification guarantees the quality
and performance of the product as an individual component. Do not use this product beyond the
specification described in this document.
