2
PS8727A 07/07/04
PI3CH360
Low Voltage, High-Bandwidth, 3-Channel, 2:1
Mux/DeMux, NanoSwitch
™
Storage Temperature ................................................ –65°C to +150°C
Ambient Temperature with Power Applied ............... –40°C to +85°C
Supply Voltage to Ground Potential ........................... –0.5V to +4.6V
DC Input Voltage ........................................................ –0.5V to +6.0V
DC Output Current................................................................... 120mA
Power Dissipation ....................................................................... 0.5W
Note:
Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the device. This is a
stress rating only and functional operation of the device at these
or any other conditions above those indicated in the operational
sections of this specication is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect re-
liability.
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
DC Electrical Characteristics, 3.3V Supply (Over Operating Range, T
A
= –40°C to +85°C, V
CC
= 3.3V ± 10%)
Parameters Description Test Conditions
(1)
Min. Typ.
(2)
Max. Units
V
IH
Input HIGH Voltage Guaranteed Logic HIGH Level 2.0 — —
VV
IL
Input LOW Voltage Guaranteed Logic LOW Level –0.5 — 0.8
V
IK
Clamp diode Voltage V
CC
= Min., I
IN
= –18mA — –1.3 –1.8
I
IH
Input HIGH Current V
CC
= Max., V
IN
= V
CC
— — ±1
µAI
IL
Input LOW Current V
CC
= Max., V
IN
= GND — — ±1
I
OZH
High-Impedence Current
(3)
0 ≤ Y, In ≤ V
CC
— — ±1
R
ON
Switch On-Resistance
(4)
V
CC
= Min.,V
IN
= 0.0V
I
ON
= –48mA or –64mA
— 4 6
Ω
V
CC
= Min., V
IN
= 3.6V, I
ON
= –15mA — 5 8
DC Electrical Characteristics, 2.5V Supply (Over Operating Range, T
A
= –40°C to +85°C, V
CC
= 2.5V ± 10%)
Parameters
(5)
Description Test Conditions Min. Typ. Max. Units
V
IH
Input HIGH Voltage Guaranteed Logic HIGH Level 1.8 – V
CC
+ 0.3
VV
IL
Inout LOW Voltage Guaranteed Logic LOW Level –0.3 – 0.8
V
IK
Clamp Diode Voltage V
CC
= Max., I
IN
= –6mA – –0.7 –1.8
I
IH
Input HIGH Current V
CC
= Max., V
IN
= V
CC
– – ±1
µAI
IL
Input LOW Current V
CC
= Max., V
IN
= GND – – ±1
I
OZH
High Impedance Current
(3)
0 ≤ Y, In ≤ V
CC
– – ±1
R
ON
Switch On-Resistance
(4)
V
CC
= Min., V
IN
=0.0V,
I
ON
= –48mA
– 6 8
Ω
V
CC
= Min., V
IN
= 2.25V,
I
ON
= -15mA
– 7 14
