TC75W56FU,LF

TC75W56FU/FK
2014-03-01
1
TOSHIBA CMOS Linear Integrated Circuit Silicon Monolithic
TC75W56FU, TC75W56FK
Dual Comparator
TC75W56 is a CMOS type general-purpose dual comparator capable of
single power supply operation and using lower supply currents than the
conventional bipolar comparators. Its push-pull output can connect
directly to local IC’s such as TTL and CMOS circuits.
Features
z Low supply current: I
DD
= 20μA (typ.)
z Single power supply operation
z Wide common mode input voltage range: V
SS
to V
DD
0.9V
z Push-pull output circuit
z Low input bias current
z Small package
Marking
(Top View)
Pin
Connection
(Top View)
Weight
SSOP8-P-0.65 : 0.021g (typ.)
SSOP8-P-0.50A : 0.01g (typ.)
Start of commercial production
1997-05
TC75W56FU/FK
2014-03-01
2
Absolute Maximum Ratings
(Ta = 25°C)
Characteristic Symbol Rating N
Supply voltage V
DD
, V
SS
±3.5 or 7 V
Differential input voltage DV
IN
±7 V
Input voltage V
IN
V
SS
to V
DD
V
Output current I
OUT
±3.5 mA
250
(TC75W56FU)
Power dissipation P
D
200
(TC75W56FK)
mW
Operating temperature T
opr
40 to 85 °C
Storage temperature T
stg
55 to 125 °C
Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the
significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even
if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum
ratings and the operating ranges.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook
(“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test
report and estimated failure rate, etc).
Note: Since this product sometimes brings about latchcap, which is peculiar to CMOS devices, note the following
points:
Don’t raise the voltage level of I/O pins beyond V
DD
, nor lower it below V
SS
.
Consider the timing for power supply, too.
Don’t let any abnormal noise enter the device.
TC75W56FU/FK
2014-03-01
3
Electrical Characteristics
(V
DD
= 5V, V
SS
= GND, Ta = 25°C)
Characteristic Symbol
Test
Circuit
Test Condition Min Typ. Max Unit
Input offset voltage V
IO
±1 ±7 mV
Input offset current I
IO
1 pA
Input bias current I
I
1 pA
Common mode input voltage CMV
IN
0 4.1 V
Supply current I
DD
(Note) 22 44 μA
Voltage gain G
V
94 dB
Sink current I
sink
V
OL
= 0.5V 13 25 mA
Source current I
source
V
OH
= 4.5V 9 21 mA
V
OL
I
sink
= 5.0mA 0.1 0.3
Output voltage
V
OH
I
source
= 5.0mA 4.7 4.9
V
Operating supply voltage V
DD
1.8 7.0 V
t
PLH
(1) Over drive = 100mV 680
Propagation delay time (turn on)
t
PLH
(2) TTL step input 500
ns
t
PHL
(1) Over drive = 100mV 250
Propagation delay time (turn off)
t
PHL
(2) TTL step i nput 380
ns
t
TLH
Over drive = 100mV
60
Response time
t
THL
Over drive = 100mV
8
ns
Electrical Characteristics
(V
DD
= 3V, V
SS
= GND, Ta = 25°C)
Characteristic Symbol
Test
Circuit
Test Condition Min Typ. Max Unit
Input offset voltage V
IO
±1 ±7 mV
Input offset current I
IO
1 pA
Input bias current I
I
1 pA
Common mode input voltage CMV
IN
0 2.1 V
Supply current I
DD
(Note) 20 40 μA
Sink current I
sink
V
OL
= 0.5V 6 18 mA
Source current I
source
V
OH
= 2.5V 3 15 mA
V
OL
I
sink
= 5.0mA 0.15 0.35
Output voltage
V
OH
I
source
= 5.0mA 2.65 2.85
V
Propagation delay time (turn on) t
PLH
Over drive = 100mV 550 ns
Propagation delay time (turn off) t
PHL
Over drive = 100mV 250 ns
t
TLH
Over drive = 100mV
30
Response time
t
THL
Over drive = 100mV
8
ns
Note: Since this product causes an increase in current consumption with a rise in operational frequency, make sure
that power consumption does not exceed the allowable dissipation.

TC75W56FU,LF

Mfr. #:
Manufacturer:
Toshiba
Description:
Analog Comparators CMOS Comparator
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet