ISL43112, ISL43113
4
FN6029.3
December 11, 2015
Submit Document Feedback
Absolute Maximum Ratings Thermal Information
V+ to V-. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3 to 15V
Input Voltages
IN (Note 6
) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ((V-) - 0.3V) to ((V+) + 0.3V)
NO, NC (Note 6
). . . . . . . . . . . . . . . . . . . . . . . . . . ((V-) - 0.3V) to ((V+) + 0.3V)
Output Voltages
COM (Note 6
). . . . . . . . . . . . . . . . . . . . . . . . . . . . ((V-) - 0.3V) to ((V+) + 0.3V)
Continuous Current (Any Terminal) . . . . . . . . . . . . . . . . . . . . . . . . . . . 20mA
Peak Current NO, NC, or COM
(Pulsed 1ms, 10% Duty Cycle, Max). . . . . . . . . . . . . . . . . . . . . . . . . 30mA
ESD Rating (Per MIL-STD-883 Method 3015). . . . . . . . . . . . . . . . . . . . >2kV
Operating Conditions
Temperature Range ISL4311XIX . . . . . . . . . . . . . . . . . . . . . -40°C to 85°C
Thermal Resistance (Typical, Note 7
)
JA
(°C/W)
5 Ld SOT-23 Package. . . . . . . . . . . . . . . . . . . . . . . . . . . . 225
8 Ld SOIC Package. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 170
Maximum Junction Temperature (Plastic Package) . . . . . . . . . . . . 150°C
Moisture Sensitivity (See Technical Brief TB363
)
All Packages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Level 1
Maximum Storage Temperature Range . . . . . . . . . . . . . . . . . . -65°C to 150°C
Pb-Free Reflow Profile . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . see TB493
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and
operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
6. Signals on NO, NC, COM, or IN exceeding V+ or V- are clamped by internal diodes. Limit forward diode current to maximum current ratings.
7.
JA
is measured with the component mounted on a low effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
Electrical Specifications ±5V Supply: Test Conditions: V
SUPPLY
= ±4.5V to ±5.5V, V
INH
= 3.5V, V
INL
= 1.5V (Note 8),
unless otherwise specified.Boldface limits apply across the operating temperature range, -40°C to +85°C.
PARAMETER TEST CONDITIONS
TEMP
(°C)
MIN
(Note 9
)TYP
MAX
(Note 9)UNIT
ANALOG SWITCH CHARACTERISTICS
Analog Signal Range, V
ANALOG
Full V- - V+ V
ON-Resistance, r
ON
V
S
= ±4.5V, I
COM
= 1.0mA, V
COM
= 3V, see Figure 4 +25 - 15 20 Ω
Full - - 25 Ω
r
ON
Flatness, r
FLAT(ON)
V
S
= ±4.5V, I
COM
= 1.0mA, V
COM
= -3V, 0V, 3V +25 - 5 6 Ω
Full - - 8 Ω
NO or NC OFF Leakage Current,
I
NO(OFF)
or I
NC(OFF)
V
S
= ±5.5V, V
COM
= ±4.5V, V
NO
or V
NC
= +4.5V, Note 10 +25 -1 0.01 1 nA
Full -5 - 5 nA
COM OFF Leakage Current, I
COM(OFF)
V
S
= ±5.5V, V
COM
= ±4.5V, V
NO
or V
NC
= +4.5V, Note 10 +25 -1 0.01 1 nA
Full -5 - 5 nA
COM ON Leakage Current, I
COM(ON)
V
S
= ±5.5V, V
COM
= V
NO
or V
NC
= ±4.5V, Note 10 +25 -2 0.01 2 nA
Full -20 - 20 nA
DIGITAL INPUT CHARACTERISTICS
Input Voltage High, V
INH
Full (V+) - 1.5 - V+ V
Input Voltage Low, V
INL
Full V- - (V+) - 3.5 V
Input Current, I
INH
, I
INL
V
S
= ±5.5V, V
IN
= 0V or V+ Full -0.5 - 0.5 µA
DYNAMIC CHARACTERISTICS
Turn-ON Time, t
ON
V
NO
or V
NC
= 3V, R
L
= 300Ω, C
L
= 35pF,
V
IN
= 0 to V+, see Figure 1
+25 - 42 70 ns
Full - 46 85 ns
Turn-OFF Time, t
OFF
V
NO
or V
NC
= 3V, R
L
= 300Ω, C
L
= 35pF,
V
IN
= 0 to V+, see Figure 1
+25 - 25 45 ns
Full - 27 50 ns
Charge Injection, Q C
L
= 1.0nF, V
G
= 0V, R
G
= 0Ω, see Figure 2 +25 - 7 20 pC
OFF Isolation R
L
= 50Ω, C
L
= 15pF, f = 100kHz, see Figure 3 +25 - >90 - dB
Power Supply Rejection Ratio R
L
= 50Ω, C
L
= 5pF, f = 1MHz +25 - 58 - dB
NO or NC OFF Capacitance, C
OFF
f = 1MHz, V
NO
or V
NC
= V
COM
= 0V, see Figure 5 +25 - 13 - pF
COM OFF Capacitance, C
COM(OFF)
f = 1MHz, V
NO
or V
NC
= V
COM
= 0V, see Figure 5 +25 - 13 - pF
COM ON Capacitance, C
COM(ON)
f = 1MHz, V
NO
or V
NC
= V
COM
= 0V, see Figure 5 +25 - 30 - pF
