58
Switching Power Supply S82K
Specifications
J NON-PFC MODELS
Item Single output Dual
outputs
Single output
Power rating 3 W 7.5 W 7.5 W 15 W 30 W 50 W
90 W
100 W 240 W
Efficiency (typical) 60% to 80% (Varies depending on specifications.)
Input
Voltage
(See
Note 1.)
AC 100 to 240 V (85 to 264 V) 120 V (85 to 132 V)/
240 V (170 to 264 V)
Selectable
120 V (85 to 132 V)/
230 V (170 to 253 V)
Selectable
DC 90 to 350 V (See Note 2.) Not possible
Frequency 50/60 Hz (47 to 450 Hz)
Current
(See
100-V
input
0.15 A
max.
0.25 A max.
0.45 A
max.
0.9 A
max.
1.3 A
max.
2.5 A max. 5.5 A max.
Note 3.)
200-V
input
0.25 A
max.
0.6 A
max.
0.8 A
max.
1.5 A max. 3.5 A max.
Leakage
current
100-V
input
0.5 mA max.
(See
Note 3.)
200-V
input
1 mA max.
Inrush
current
100-V
input
15 A max. 25 A max.
(See
Note 3.)
200-V
input
30 A max. 50 A max.
Noise filter Yes
Output (See Note 4.)
Voltage adjustment
range
r10% (V.ADJ) Not pos-
sible (See
Note 5.)
r10% (V.ADJ); –10% to 15% for S82K-03012/-03024/-05024
Ripple (See
Note 3.)
2% (p-p) max.
Input variation
influence
0.5 % max. (at 85 to 264 VAC, 100% load) 0.5 % max. (at 85 to
132 VAC/
170 to 264 VAC input,
100% load)
0.5 % max. (at 85 to
132 VAC/170 to
253 VAC input,
100% load)
Load variation
influence
1.5% max.
(0 to 100%
load)
+V: 1.5%
max.
-V: 3 %
max.
(0 to
100%
load)
1.5%
max.
(0 to
100%
load)
1.5% max. (10 to 100% load)
Temperature
variation influence
(See Note 3.)
0.05%/qC max.
Startup time 100 ms max. (up to 90% of output voltage at rated input
and output)
200 ms max. 300 ms max.
Hold time
(See Note 3.)
20 ms min.
(This table continues on the next page.)
Note: 1. Use with DC voltage input is beyond the conditions of approval or conformance to applicable safety standards.
2. Use the 7.5-W single-output models under the load of 90% max. if the voltage range is between 90 and 110 VDC.
3. Defined with a 100% load and the rated input voltage (100 or 200 VAC).
4. The output specification is defined at the power supply output terminals.
5. The settings for the output voltage must be within the following range:
+V: r1% of the rated value
–V: r5% of the rated value