https://www.phoenixcontact.com/pi/products/2961422
08/20/2018Page2/5
Single relay-REL-MR-230AC/21HC-2961422
Technical data
Coil side
Typical release time range 2 ms ... 9 ms (depending on phase relation)
Coil resistance 32500 Ω ±15 % (at 20 °C)
Power dissipation for nominal condition 0.4 W
Contact side
Contact type 1 PDT
Type of switch contact Single contact
Contact material AgNi
Maximum switching voltage 250 V AC/DC
Minimum switching voltage 12 V (at 10 mA)
Min. switching current 10 mA (at 12 V)
Maximum inrush current 25 A (20 ms)
Limiting continuous current 16 A
Interrupting rating (ohmic load) max. 384 W (at 24 V DC)
58 W (at 48 V DC)
48 W (at 60 V DC)
50 W (at 110 V DC)
80 W (at 220 V DC)
4000 VA (for 250 V AC)
Switching capacity in acc. with DIN VDE 0660/IEC 60947 2 A (at 24 V, DC13)
0.2 A (at 110 V, DC13)
0.2 A (at 250 V, DC13)
6 A (at 24 V, AC15)
6 A (at 120 V, AC15)
6 A (at 250 V, AC15)
General
Test voltage relay winding/relay contact 5 kV AC (50 Hz, 1 min.)
Operating mode 100% operating factor
Degree of protection RT II (flux-proof)
Mechanical service life
1x 10
7
cycles
Mounting position any
Assembly instructions Can be aligned without spacing (> 70 °C ≥ 2.5 mm)
Standards and Regulations
Connection in acc. with standard CUL
Standards/regulations IEC60664
EN 50178
EN 61810-1
Degree of pollution 3
Overvoltage category III
Environmental Product Compliance
