PLUG ASSEMBLY
BOTTOM HOUSING
TOP HOUSING
PLUG HANDLE
CABLE CLAMP
BOOT
CABLE
MALE HOUSING
SOLDER TABS FOR
GROUND TERMINAL
SLIDE ASSEMBLY IN
SEE NOTE 3
CONTACT WIRES
3 CONDUCTOR SHOWN
GROUND WIRE TO SOLDER
INTO MALE HOUSING TAB
SEE NOTE 4
SEE NOTE 2
INSTRUCTIONS:
1) CUT THE WIRES ACCORDINGLY AS SHOWN ABOVE.
2) RUN IT THROUGH INSULATOR AND SOLDER THE CONTACT WIRES TO THE PLUG ASSEMBLY. CONNECT
THE INSULATOR TO THE PLUG ASSEMBLY.
3) NOW SLIDE THE CONNECTED PLUG ASEMBLY, INSULATOR INTO THE TINI QG HOUSING. MAKE
SURE THAT THE PLUG ASSEMBLY IS BUTTED UP AGAINST THE FRONT OF THE TINI QG HOUSING.
4) SOLDER THE GROUND TERMINAL WIRE TO THE TINI QG HOUSINGS'S LOWER THRU HOLE AS SHOWN.
5) SLIDE THE BOTTOM PLASTIC HOUSING UP TOWARDS THE MALE HOUSING
6) DROP AND SLIDE THE TOP RIGHT ANGLE HOUSING INTO THE GROVE SUCH AS IT LATCHES WITH THE
BOTTOM PLASTIC AND MALE HOUSING.
7) SLIDE THE CABLE CLAMP THROUGH THE CABLE INTO THE TOP/BOT HOUSINGS AS SHOWN.
8) SCREW THE PLUG HANDLE AND POP IN THE BOOT TO ASSEMBLE FULL PRODUCT.
CABLE OD RANGE
0.120 -
0.150IN
SEE NOTE 5
SEE NOTE 6
SEE NOTE 7
SEE NOTE 8
0.40
10.2
0.13
3.2
0.85
21.6
GROUND TERMINAL WIRE
WIRE STRIPPING DIMENSIONS
SEE NOTE 1
INSULATOR
RIGHT ANGLE TINI QG ASSEMBLY
DO NOT SCALE DRAWING
REVISIONS
APVD
BY
DATE
ECO NUMBER
REV
REV
PART No.
NAME
OF
SHEET
APVD
CHKD
BY
DATE DRAWN
SCALE
FIRST USED ON
SPEC No.SPEC No.
MATERIAL
FINISH
UNLESS OTHERWISE SPECIFIED
TEMPER
LBS/M
MULT
WIDTH
SIZE
THIS DRAWING DESCRIBES A DESIGN CONSIDERED PROPRIETARY IN NATURE, DEVELOPED AND MANUFACTURED
BY SWITCHCRAFT INC. AND IS RELEASED ON A CONFIDENTIAL BASIS FOR IDENTIFICATION PURPOSES ONLY.
B
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
1:1
01/03/17
AM
*
*
*
*
1
1
TINI QG, MALE RA, RoHS
TARA_MX SERIES_CD
0A
1. ALL DIMENSIONS IN INCHES [mm]
- TWO PLACE DECIMALS
0.02 [0.5]
- THREE PLACE DECIMALS
0.005 [0.13]
SolidWorks CAD File
PRELIMINARY
CUSTOMER DRAWING
