TE CONNECTIVITY, SWINDON, UK
While TE Connectivity has made every reasonable effort to ensure the accuracy of the information in this specification, TE Connectivity does not guarantee that it is
error-free, nor does TE Connectivity make any other representation, warranty or guarantee that the information is accurate, correct, reliable or current. TE Connectivity
reserves the right to make any adjustments to the information contained herein at any time without notice. TE Connectivity expressly disclaims all implied warranties
regarding the information contained herein, including, but not limited to, any implied warranties of merchantability or fitness for a particular purpose. The dimensions in
this document are for reference purposes only and are subject to change without notice. Specifications are subject to change without notice. Consult TE Connectivity for
the latest dimensions and design specifications.
If this document is printed it becomes uncontrolled.
TABLE 2
Requirements
In accordance with Table 1
ASTM D 638 RW-2500
Section 4.3.2.2
1/8" wide die cut
specimens
2 inches/ min strain
rate.
Low Temperature Flexibility
No dripping, flowing or
cracking
168 hours at 175°C (347°F)
Corrosive Effect
16 hours at 175°C (347°F)
Procedure A
RW-2500
Section 4.3.13.2
Notes
1.In accordance with Section 4.3.5.2 except that specimens shall be bent 90° over a 1-inch dia. mandrel.
2.Specimens shall be bent 90° over a 5/16-inch dia. mandrel.