MC74HC4316A
http://onsemi.com
3
MAXIMUM RATINGS
Symbol Parameter Value Unit
V
CC
Positive DC Supply Voltage (Ref. to GND)
(Ref. to V
EE
)
– 0.5 to + 7.0
– 0.5 to + 14.0
V
V
EE
Negative DC Supply Voltage (Ref. to GND) – 7.0 to + 0.5 V
V
IS
Analog Input Voltage V
EE
– 0.5
to V
CC
+ 0.5
V
V
in
DC Input Voltage (Ref. to GND) – 0.5 to V
CC
+ 0.5 V
I DC Current Into or Out of Any Pin ± 25 mA
P
D
Power Dissipation in Still Air Plastic DIP*
EIAJ/SOIC Package*
TSSOP Package*
750
500
450
mW
T
stg
Storage Temperature – 65 to + 150 °C
T
L
Lead Temperature, 1 mm from Case for 10 Seconds
(Plastic DIP, SOIC or TSSOP Package)
260
°C
Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress
ratings only. Functional operation above the Recommended Operating Conditions is not implied.
Extended exposure to stresses above the Recommended Operating Conditions may affect
device reliability.
*Derating − Plastic DIP: – 10 mW/°C from 65° to 125°C
EIAJ/SOIC Package: – 7 mW/°C from 65° to 125°C
TSSOP Package: − 6.1 mW/°C from 65° to 125°C
RECOMMENDED OPERATING CONDITIONS
Symbol Parameter Min Max Unit
V
CC
Positive DC Supply Voltage (Ref. to GND) 2.0 6.0 V
V
EE
Negative DC Supply Voltage (Ref. to GND) – 6.0 GND V
V
IS
Analog Input Voltage V
EE
V
CC
V
V
in
Digital Input Voltage (Ref. to GND) GND V
CC
V
V
IO
* Static or Dynamic Voltage Across Switch − 1.2 V
T
A
Operating Temperature, All Package Types – 55 + 125 °C
t
r
, t
f
Input Rise and Fall Time V
CC
= 2.0 V
(Control or Enable Inputs) V
CC
= 3.0 V
(Figure 10) V
CC
= 4.5 V
V
CC
= 6.0 V
0
0
0
0
1000
600
500
400
ns
*For voltage drops across the switch greater than 1.2 V (switch on), excessive V
CC
current may
be drawn; i.e., the current out of the switch may contain both V
CC
and switch input components.
The reliability of the device will be unaffected unless the Maximum Ratings are exceeded.
This device contains protection
circuitry to guard against damage
due to high static voltages or electric
fields. However, precautions must
be taken to avoid applications of any
voltage higher than maximum rated
voltages to this high−impedance cir-
cuit. For proper operation, V
in
and
V
out
should be constrained to the
range GND v (V
in
or V
out
) v V
CC
.
Unused inputs must always be
tied to an appropriate logic voltage
level (e.g., either GND or V
CC
).
Unused outputs must be left open.
I/O pins must be connected to a
properly terminated line or bus.