12
Package Characteristics
All specifications are at T
A
=+25°C.
Parameter Symbol Min. Typ. Max. Units Test Conditions
Input-Output Momentary SO8 V
ISO
2500 V
RMS
RH ≤50%, t = 1 min
Withstand Voltage
[9]
SO16 V
ISO
2500 RH ≤ 50%, t = 1 min
Input-Output Insulation
[10] [11]
SO8 I
I-O
5 µA 45% RH, t=5 sec, V
I-O
= 3kV DC
SO16 I
I-O
5 45% RH, t=5 sec, V
I-O
=3kV DC
Input-Output Resistance
[10]
SO8 R
I-O
10
9
10
11
Ω V
I-O
= 500V DC
SO16 R
I-O
10
9
10
11
V
I-O
= 500V DC
Input-Output Capacitance
[10]
SO8 C
I-O
0.7 pF f = 1 MHz
SO16 C
I-O
0.7 f = 1 MHz
Input-Input Insulation SO8 I
I-I
0.005 µARH≤45%, t= 5 sec, V
I-I
= 500V
Leakage Current
[12]
SO16 I
I-I
0.005 RH ≤ 45%, t = 5 sec, V
I-I
= 500V
Input-Input Resistance
[12]
SO8 R
I-I
10
11
Ω RH ≤45%, t= 5 sec, V
I-I
= 500V
SO16 R
I-I
10
11
RH ≤45%, t =5 sec, V
I-I
=500V
Input-Input Capacitance
[12]
SO8 C
I-I
0.1 pF f = 1 MHz
SO16 C
I-I
0.12 f = 1 MHz
Electrostatic Discharge Sensitivity
This product has been tested for
electrostatic sensitivity to the
limits stated in the specifications.
However, Avago recommends that
all integrated circuits be handled
with appropriate care to avoid
damage. Damage caused by
inappropriate handling or storage
could range from performance
degradation to complete failure.
Notes:
9. V
ISO
is a dielectric voltage rating that should
not be interpreted as an input-output
continuous voltage rating. For continuous
voltage rating, refer to the IEC/EN/DIN EN
60747-5-2 Insulation Characteristics Table (if
applicable), the equipment level safety
specification or Avago Application Note 1074
entitled “Optocoupler Input-Output
Endurance Voltage.”
10. Measured between each input pair shorted
together and all output connections for that
channel shorted together.
11. In accordance to UL1577, each optocoupler
is proof tested by applying an insulation test
voltage ≥ 3000 Vrms for 1 sec (leakage
detection current limit, I
I-O
≤ 5 µA). This test
is performed before the 100% production test
for partial discharge (Method b) shown in the
IEC/EN/DIN EN 60747-5-2 Insulation
Characteristics Table, if applicable.
12. Measured between inputs with the LED
anode and cathode shorted together.