GPS-14030 Datasheet GPS-14030 | P1-P3

Mini GPS Shield

GPS-14030

Description:TheSparkFunMiniGPSShieldequipsyourArduinoMiniwithaccesstoaGPSmodule,µSD

memorycardsocketandalloftheotherperipheralsyou’llneedtoturnyourArduinointoaposition‐

tracking,speed‐monitoring,altitude‐observingwonderlogger.TheshieldisbasedaroundtheGP‐735

GPSmodule,a56‐channelGPSreceiverfeaturingauBlox7thgenerationchipsetandanupto10Hz

updaterate.Theboardalsousesalevelshifter,sothere’snoneedtoworryaboutthelogicvoltageof

yourArduinoMini.

TheMiniGPSShieldisaminiversionof

ourGPSLoggerShield.WhiletheGPSLoggerShieldwasdesigned

toworkwiththeArduinoRedBoard,theMiniGPSShieldwasdesignedtoworkwiththeArduino

Mini/Microboards.

The shield comes with a 6-pin JST connector to connect the GP-735 module. If you already

have a GPS module, the JST pins are broken out and labeled to allow you to use just about any

GPS module that works down to 3.3V. The Mini GPS Shield will work with any of our Arduino

Mini boards. The board uses 3.3V logic; however, the logic level converter on the shield allows

you to use 5V boards just as easily. The mini boards have symmetrical pins, which means it’s

very easy to plug the shield in the wrong way. Plugging the shield in backward won’t damage

either board, but it is something that could be easy to overlook. Make sure to check out the

Hookup Guide below for proper installation instructions.

Features:

Supports GP-735 with pins broken out to support most 3.3V tolerant GPS modules

Supports backup battery options

uSD memory card socket

Works with any Arduino Mini board (3.3V or 5V)

UART switch controls serial communications

Configurable LED to show GPS fix

SparkFunElectronics®

Mfr. #:

Manufacturer:

SparkFun

Description:

GPS Development Tools Mini GPS Shield

Lifecycle:

New from this manufacturer.

Delivery:

DHL FedEx Ups TNT EMS

Payment:

T/T Paypal Visa MoneyGram Western Union