ASSR-1611
High Current, 1 Form A, Solid State Relay (MOSFET)
(60V/2.5A/0.1)
Data Sheet
Description
The ASSR-1611 is speci cally designed for high current
applications, commonly found in the industrial equip-
ments. The relay is a solid-state replacement for single-
pole, normally-open, (1 Form A) electromechani cal relays.
The ASSR-1611 consists of an AlGaAs infra red light-emit-
ting diode (LED) input stage optically coupled to a high-
voltage output detector circuit. The detector consists of a
high-speed photovoltaic diode array and driver circuitry
to switch on/o two discrete high voltage MOSFETs. The
relay turns on (contact closes) with a minimum input cur-
rent of 5mA through the input LED. The relay turns o
(contact opens) with an input voltage of 0.8V or less.
The ASSR-1611 connection A, as shown in the schematic,
allows the relay to switch either ac or dc loads. The con-
nection B, with its advantages of reduced on-resistance
and higher output current, allows the relays to switch dc
loads only.
The electrical and switching characteristics are speci ed
over the tem perature range of -40°C to +85°C.
Functional Diagram
Features
Compact Solid-State Bi-directional Signal Switch
Single Channel Normally-o Single-Pole-Single-Throw
(SPST) Relay
60V Output Withstand Voltage
2.5A or 5A Current Rating
Low Input Current: CMOS Compatibility
Low On-Resistance: 20m Typical for DC-only, 65m
Typical for AC/DC
High Speed Switching: 3.2ms (T
on
), 0.1ms (T
o
) Typical
High Transient Immunity: >1kV/s
High Input-to-Output Insulation Voltage
- (Safety and Regulatory Approvals)
UL recognized - 3750 V
RMS
and 5000 V
RMS
* for 1 min
per UL1577
- CSA Component Acceptance
*5000 V
RMS
/1 Minute rating is for Option X21 only.
(Please consult your regional Avago representatives)
Applications
Industrial Controls
Factory Automation
Data Acquisition
Measuring Instrument
Medical System
Security System
EMR / Reed Relay Replacement
CAUTION: It is advised that normal static precautions be taken in handling and assembly
of this component to prevent damage and/or degradation which may be induced by ESD.
Truth Table
LED Output
O Open
On Close
Opto-isolation
1
2
3
4
6
5
Opto-isolation
1
2
3
4
6
5
Turn-off
Circuit