PDA050W Multi-Channel Characteristics
INPUT:
AC Input Voltage
108 to 304V AC
Nominal AC Input Voltage
120~277VAC
Leakage Current
<3.5mA at 277VAC – Case to Ground
<0.25mA at 277VAC – Outputs to Ground
Maximum Input Current
0.55A (RMS) at 108VAC, 60Hz
AC Inrush Current
<30A at 277VAC, 60Hz
OUTPUT:
Total Output Power
Maximum output should be <52W
Efficiency
>82% at 120VAC, >84% at 277VAC
Standby Power
<2.5W maximum
Power Factor
≥0.9 at nominal input voltage, full load
Ripple (CH1~CH4)
240mA p-p
Turn on/off Time
0.5 seconds maximum at nominal AC input
ENVIRONMENTAL:
Operating Temperature 0 to +50°C
Storage Temperature -40 to +85°C
Operating Humidity 10 to 95%
Storage Humidity 5 to 95%
Case Temperature
Case may not exceed 70°C at ambient 50°C
Dimming
Cut off Current at 1.V
Dim. Voltage
Driver shall provide
95mA ± 10% Current
Driver 10V shall
provide 100% Output
(453mA ± 5%)
100% brightness without dimmer: Open state for dimming port
EMC
FCC 47 Part 15 Class A
Immunity
EN61000-4-2 Criteria B
EN61000-4-3
EN61000-4-4
EN61000-4-5 Criteria B
EN61000-4-6
EN61000-4-8
EN61000-4-11
EN61000-3-2 Class C
Isolation Test
Primary to Secondary: 3000VAC, <5mA, 1 minute
Insulation Resistance
Primary to Secondary: 500VDC, >5M ohm, 1 minute
FEATURES:
Input Over Current Protection
The input power line will be fused with a 2A/300V fuse resistor
Short Circuit Protection
Auto restart without damage
Output Overvoltage Protection
Auto shut down
Open Circuit Protection
Once the circuit is opened, the output voltage should be less
than 140% at nominal AC input conditions
Open Temperature Protection
Wires
Output Connector
Molex 8 pin p/n – 09-50-1081 mate p/n – 09-65-2088
Ingression Protection
IP65
Warranty
5 Years
