Phone: 914-793-0700 • Fax: 914-793-4527
sales@jonard.com • www.jonard.com
Turning Receiver ON and OFF
Turn ON Press and release the ON/OFF Button. While, the receiver is
initializing the directional arrow lights will flash in a clockwise rotation.
When, the lights stop flashing the receiver is ready to use. To verify that the
receiver unit is on, press and release the ON/OFF button and the directional
light closest to the ON/OFF button will flash once.
Turn OFF Press and hold the ON/OFF button until the directional lights
start flashing in a counter-clockwise motion.
Auto Shut Down If the receiver does not receive a signal from the
transmitter for 3 minutes it will go into an auto shut down mode and will
turn off.
Low Battery Indicator If the battery voltage drops below the required
voltage all four directional lights will blink three times at one minute inter-
vals until the battery is replaced
Using MP-800 Reference Point Locator
Place the transmitter on the wall by pushing DRYWALLPIN into the drywall
until the face of the transmitter is flush with the wall surface as shown in
Fig 3. or use a removable adhesive as shown in Fig. 4. The transmitter does
not need to be parallel to the wall. The receiver will automatically correct
for the misalignment as shown in FIG 4. Once the transmitter has been
positioned on the dry wall place the receiver on the wall as shown in
FIG. 5. When the receiver is within range of the transmitter two
DIRECTIONAL ARROW LIGHTS will illuminate indicating the direction of
the transmitter relative to the receiver. Move the receiver in the direction
indicated by the DIRECTIONAL ARROWS. When the receiver is centered
with the transmitter in both directions all four DIRECTIONAL ARROWS will
be illuminated.
Turning Transmitter ON and OFF
Turn ON and OFF Use the ON/OFF Switch shown in Fig. 2. When the ON/
OFF switch is in the ON position the green on light will be illuminated indi-
cating the transmitter is on.
Low Battery Indicator If the battery voltage drops below the required
voltage the yellow LOW Voltage light will illuminate indicating that the
battery must be replaced.
Replacing the DRYWALL PIN To replace the DRYWALL PIN loosen the PIN
RELEASE SCREW until the DRYWALL PIN is released from the housing.
DIRECTIONS
Determining Drill Angle to the Transmitter
Place the transmitter on the wall by pushing DRYWALL PIN into the drywall
until the face of the transmitter is flush with thewall surface at the desired
drill exit location as shown in Fig 6. Once the transmitter has been
positioned on the dry wall place the receiver on the wall at the drill
entrance location as shown in Fig. 6. Rotate the receiver towards the
illumined DIRECTIONAL ARROWS until all four DIRECTIONAL ARROWS are
illuminated. This indicates that the center line of the MARKING HOLE is
aligned correctly to pass through the center of the transmitter as shown in
Fig. 6.
NOTE: Only use Alkaline Batteries
