J
Series JL
Illuminated Ultra-Thin Tactiles
www.nkk.com
J46
Indicators
AccessoriesSupplement
Tactiles
KeylocksRotaries
Pushbuttons
Illuminated PB
Slides
Programmable
Rockers
Touch Tilt
Toggles
Electrical Capacity (Resistive Load)
Low/Logic Level: 50mA @ 24V DC
Other Ratings
Contact Resistance: 50 milliohms maximum
Insulation Resistance: 500 megohms minimum @ 250V DC
Dielectric Strength: 250V AC minimum for 1 minute minimum
Mechanical Life: 1,000,000 operations minimum
Electrical Life: 1,000,000 operations minimum
Nominal Operating Force: 3.0N
Total Travel: .030” (0.75mm)
Materials & Finishes
Actuator: Polycarbonate
Case: Glass fiber reinforced polyamide
Base: Glass fiber reinforced polybutylene terephthalate (PBT)
Movable Contact: Stainless steel
Stationary Contacts: Brass with silver plating
Switch Terminals: Brass with silver plating
Lamp Terminals: Brass with tin plating
Environmental Data
Operating Temperature Range: –25°C through +50°C (–13°F through +122°F)
Humidity: 90 ~ 95% humidity for 240 hours @ 40°C (104°F)
Vibration: 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning
in 1 minute; 3 right angled directions for 2 hours
Shock: 50G (490m/s
2
) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)
PCB Processing
Soldering: Wave Soldering: See Profile A in Supplement section.
Manual Soldering: See Profile A in Supplement section.
Cleaning: These devices are not process sealed. Hand clean locally using alcohol based solution.
Standards & Certifications
The JL Series tactiles have not been tested for UL recognition or CSA certification.
These switches are designed for use in a low-voltage, low-current circuit.
When used as intended, the results do not produce hazardous energy.
General Specifications
