Rev 1.0 1/24/2008
Technical Details
The DB-LQFP48-LPC2103 uses a
PCB edge finger connector to
interface to the USB-Dongle.
Board Dimensions 2.268” x 1.5”
Target Interface
The USB-Dongle includes a 14 pin connector to the Derivative Board
that utilizes the following signals. Not all signals are used on all
Derivative Boards:
ISP/ICPn 5V (USB power, unswitched)
Switched Power (3V for ICP) or
Reset (High True for 8051 ISP)
Reset (Low True)
(for ICP & LPC2000 ARM)
Ground 3V (unswitched)
PCL/SCL (ICP/I2C) PDA/SDA (ICP/I2C)
TXD (UART) RXD (UART)
MSIO (SPI) PSEN/P0.14 (ISP entry)
SCLK (SPI) MOSI (SPI)
Example of USB-Dongle and Derivative Board
USB-Dongle
DB-HVSON10-LPC9103
Headers – The DB-LQFP48-LPC2103 brings every pin of the microcontroller out to a standard 0.10” spacing
header footprint for easy probing of signals or to support prototyping or wire-wrapping. Consult the DB-LQFP48-
LPC2103 schematic if there are any questions about pin alignment from the microcontroller to the headers.
Power – The USB-Dongle provides the regulated 3.3V power required by the DB-LQFP48-LPC2103 and an
onboard LDO, U3, provides the regulated 1.8V. The DB has a power measurement jumper, JP1, to allow the user to
easily measure the power consumption of the microcontroller. In the artwork, JP1 pin 1 is shorted to pin 2 so the
board is continuously powered. The board can be easily modified by cutting JP1 and loading a standard 0.10” header.
LED - A green activity or status LED is provided at location D1 on the Derivative Board. This LED can be used to
indicate when the microcontroller is being programmed or for other types of user activity under software control.
Crystal or Clock Frequency - The DB-LQFP48-LPC2103 is clocked by an external 12.000 MHz crystal oscillator
located at position Y1 on the DB.
Ordering Information
Order Online at www.digikey.com FDI Contact Info:
Digi-Key Part #: 622-1013-ND (800) 278-0293 Phone
Availability: Stock (256) 883-1241 FAX
Digi-Key Contact Info:
1-800-DIGI-KEY Phone www.teamfdi.com
(218) 681-3380 FAX
All brand names and product names are trademarks or registered trademarks of their respective holders.