https://www.phoenixcontact.com/us/products/1411187
03/15/2016Page4/4
Cable gland-G-INSEC-M12-S68N-NCRS-S-1411187
Functional drawing
Assembly instructions:
Method 1
Slit the outer sheath after approximately 15 mm, but do not remove it. Guide the cable through the screw connection and then remove the outer sheath.
Now withdraw the cable until a connection is established between the conductor shield and the contact spring.
Method 2
Push the braided shield back approximately 15 - 20 mm over the outer sheath. Insert the cable into the screw connection until a connection is
established between the conductor shield and the contact spring.
Method 3
Uncover about 10 mm of the braided shield and guide the cable through the screw connection until a connection is established between the conductor
shield and the contact spring.
Phoenix Contact 2016 © - all rights reserved
http://www.phoenixcontact.com
