MPS-120-48 Datasheet MPS-120-48, MPS-120-5, MPS-120-24 | P1-P3

Specification

(Typ.)

ACINPUTVOLTAGE

ACINPUTCURRENT

INRUSHCURRENT

SETUP,RISETIME

HOLD-UP TIME

LEAKAGECURRENT

DCOUTPUT ADJ.RANGE

OVERLOADPROTECTION

OVERVOLTAGEPROTECTION

POWERGOOD/FAIL SIGNAL (OPTIONAL)

WORKINGTEMP.

WORKINGHUMIDITY

STORAGETEMP.,HUMIDITY

90~264VAC,47~440Hz/127~370VDC.

Maximuminputcurrent2.9A at115VAC,60Hzor

1.7A at230VAC,60Hzwith100%outputload.

Inrushcurrentislessthan22A at115VACorlessthan

45A at230VACundercoldstartconditions.Limiting

providedbyinternalthermistors.

MPS-120: 800ms,20ms/230VACatfullload

2000ms,50ms/115VACatfullload

MPD,T,Q-120:500ms,20ms/230VACatfullload

1200ms,50ms/115VACatfullload

80ms/230VACatfullload

14ms/115VACatfullload

Leakagecurrentislessthan180 A at264VAC

DCoutputvoltage(orCh1ofmultipleoutputmodels)

canbeadjustedbetween-5%~+10%ratedoutput

voltagebypotentialmeter.

Fullyprotectedagainstshortcircuitandoutputoverload.

Thehiccuptypeprotection willbeactivatedat110~150%

(ForMPD,T,Q-120),120~160%(ForMPS-120)ratedload

andrecoversautomaticallyafterfaultconditionis removed.

Providedonoutputchannel1onlyat115%~135%

ratedoutputvoltage.(120%~140%forMPS-120-15/24/48).

Outputwillbeshutdownwhenthisprotectionisactivated.

*MPS-120-3.3doesnothavethisoptionalfunction.

Wholeseriescanoperatefrom-20~70 .Pleaserefer

tothederatingcurves.

20~90%RHnon-condensing.

-40~+85 ,10~90%RH

TTL logichighforpowergoodand TTL lowfor

powerfail.Whentheoutputvoltagereaches90%of

ratedvalue,a+5V TTL signalwillbesentoutwitha

10~500msdelay; Atleast1msbeforetheoutput

voltagegoesbelow90%oftheratedvalue,the TTL

signalwillbeturnedoff.

ComplianceLevel

EN55011,ClassB

EN55022,ClassB

EN61000-3-2

EN61000-3-3

ComplianceLevel

EN61000-4-2,

EN61000-4-3,

EN61000-4-4,

EN61000-4-5,

EN61000-4-6,

EN61000-4-8,

EN61000-4-11,

ENV50204,

Level3,8KV

Level2,4KV

Level2,3V/m

Level3,10V/m

Level2,1KV/5KHz

Level3,2KV/5KHz

Level4,2KV/Line-Line

4KV/Line-Earth

Level2,3Vrms/m

Level3,10Vrms/m

Level2,3A/m

Level3,10A/m

Compliance

Level2,3V/m,900MHz

Level3,10A/m,900MHz

1~4OutputMedical Type

120WMedical ser i e s

Universal ACinput/Fullrange

Lowleakagecurrent<180 A

Protections:Shortcircuit/Overload/Overvoltage

UL60601-1medicalsafetyapproved

Withpowergoodandfailsignaloutput(Optional)

100%fullloadburn-intest

Fixedswitchingfrequencyat45KHz

3yearswarranty

Features

TEMP.COEFFICIENT

VIBRATION

SAFETY STANDARDS

WITHSTANDVOLTAGE

ISOLATIONRESISTANCE

EMICOMPLIANCE

EMSCOMPLIANCE

MTBF

DIMENSION(L*W*H)

PACKING

2Gofacceleration,vibratingfrequencyadjustfrom10Hz~500Hzwithina

10-minutecycle.6testingcycles(60minutes)eachalongX, Y,Zaxes.

Medical UL60601-1, TUVEN60601-1 approved

Commercial: AlsodesignrefertoUL60950-1, TUVEN60950-1

4000VACbetweeninputandoutput

1500VACbetweeninputandF.G.

500VACbetweenoutputandF.G.

EMISpecifications

EMSSpecification

ESDair

ESDcontact

RFfieldsusceptibility

EFT(ElectricalFast Transient)/Burst

Lightning/Surge

ConductedRFsusceptibility

Magneticfieldimmunity

Voltagedip,interruption

Digitalphonecarrierimmunity

262,100hoursmin.atfullloadand25 ofambienttemperature,

calculatedperMIL-HDBK-217F.

177.8x107.95x35.5mmor7"x4.25"x1.4"

0.55Kg;24pcs/14.5Kg/0.99CUFT

0.04%/ onalloutputsatfullloadbetween0~50 ofambienttemperature.

>100MOhmsforI/P-O/P,I/P-FG,O/P-FGbyusing500VDCtestvoltage.

Conducted&Radiation

Harmonicdistortion

Voltageflicker

IEC60601-1

FileName:120WMEDICAL-SPEC2011-03-31

EN60601-1

IEC60601-1

1~4OutputMedical Type

120WMedical ser i e s

Notes:

1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.

2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1 f & 47 f parallel capacitor.

3. Tolerance : includes set up tolerance, line regulation and load regulation.

4. 33% Duty cycle maximum within every 30 seconds. Average output power should not exceed the rated power.

5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets

EMC directives.

6. Heat Sink HS1,HS2 can not be shorted.

For guidance on how to perform these EMC tests, please refer to EMI testing of component power supplies.

(as available on http://www.meanwell.com)

OutputChart

MODEL

OUTPUT RATED

OUTPUTCURRENT

PEAKLOAD

WITHFAN

CONVECTION

MINIMUM

RIPPLE&NOISE

VOLTAGE

LINE LOAD

EFFICIENCY

VOLTAGE CURRENT

( )Note4

(25CFM)

(max.)

LOAD

(Max.)

TOLERANCE

REGULATION

MPS-120-3.3

3.3V 0A24A 16A 24A 26A 80mVp-p 3.0% 1.0% 3.0% 68%

73%

77%

79%

81%

82%

75%

72%

73%

72%

71%

74%

73%

74%

76%

1.0% 3.0%

1.0% 2.0%

2.0%

0.5%

1.0%

0.5%

1.0%

3.5%

3.0%

+4,-3%

1.0%

3.5%

3.0%

1.0%

0.5%

3.5%

4.0%

1.0%

0.5%

1.5%

2.0%

1.5%

2.0%

3.0%

0.5%

2.0%

0.5%

2.0%

3.0%

2.0%

6.0%

2.0%

6.0%

+6,-7%

6.0%

+6,-7%

+8,-6%

5.0%

8.0%

5.0%

2.0%

7.0%

8.0%

80mVp-p

100mVp-p

120mVp-p

80mVp-p

120mVp-p

150mVp-p

120mVp-p

150mVp-p

120mVp-p

300mVp-p

80mVp-p

300mVp-p

80mVp-p

120mVp-p

80mVp-p

120mVp-p

250mVp-p

5V 0A22A 14.7A 22A

26A

0A10A 6.7A 10A 11A

0A8A 5.3A 8A 8.8A

0A5A 3.3A 5A 5.5A

0.4A

0.5A

0.2A

0.5A

0.4A

0.3A

0.5A

0.3A

2.5A

10A

4.8A

4.4A

4.2A

3.2A

2.2A

0.6A

2.1A

0.6A

10A

2.9A

1.7A

7.3A

3.5A

3.2A

2.6A

3.1A

2.4A

0.7A

2.3A

1.6A

0.3A

0.4A

1.4A

0.4A

0.3A

0.4A

3.6A

1.9A

2.5A

10A

4.8A

4.4A

4.2A

3.2A

2.2A

0.6A

2.1A

0.6A

10A

2.9A

2.8A

12A

11A

12A

5.8A

5.3A

4.4A

3.8A

1.1A

3.3A

2.64A

2.3A

12A

3.2A

12V

15V

24V

48V

12V

15V

12V

15V

12V

24V

-5V

-12V

-15V

-5V

24V

15V

-12V

-15V

-12V

24V

12V

24V

MPS-120-5

MPS-120-12

MPS-120-15

MPS-120-24

MPS-120-48

MPD-120A

MPT-120A

MPT-120B

MPT-120C

MPQ-120B

MPQ-120C

MPQ-120D

MPQ-120E

MPT-120D

MPD-120B

WITH25CFMFAN

(Note3)

(Note2)

FileName:120WMEDICAL-SPEC2011-03-31

(HORIZONTAL)

HS1,HS2 can not be shorted

ACInputConnector(CN1):Molex5273-05orequivalent

DCOutputConnector(CN2):Molex5273-13orequivalent

PinNo.

2,4

MPS-120

MPD-120

MPT-120

MPQ-120

MatingHousing

Terminal

AC/L

-V

P.F.D.

NoPin

AC/L

COM

P.F.D.

NoPin

AC/L

COM

P.F.D.

NoPin

AC/L

COM

P.F.D.

NoPin

AC/N AC/N AC/N AC/N

Molex5195

Molex5194

orequivalent

FG FG FG FG

Unit:mm

MechanicalSpecification

95.25[3.75"]

107.95[4.25"]

165.1[6.5"]

177.8[7"]

CN2

+V ADJ

HS2

HS1

CN1

4- 3.96[0.156"]

FAN

10cm

DeratingCurve

Pin Assignment

StaticCharacteristics

90 100 115 135 155 264230

100

INPUTVOLTAGE(V)60Hz

LOAD(%)

1~4OutputMedical Type

120WMedical ser i e s

FileName:120WMEDICAL-SPEC2011-03-31

LOAD(%)

10 20 30 40 50 55 60 70

100

-20 0

25CFMforcedaircooling

Convectioncooling

53WMPS-120-3.3only

73.7WMPS-120-5only

80Wothers

AMBIENTTEMPERATURE( )

MPS/D-120

MPT/Q-120

35.5[1.4"]

2 max.[0.078"]

P1-P3

MPS-120-48

Mfr. #:

Buy MPS-120-48

Manufacturer:

Description:

AC to DC Power Supply Open Frame Single Output 48 Volt 1.7 A

Lifecycle:

New from this manufacturer.

Delivery:

DHL FedEx Ups TNT EMS

Payment:

T/T Paypal Visa MoneyGram Western Union

MPS-120-48

MPS-120-48

Products related to this Datasheet