ACPL-P481 and ACPL-W481
Inverted Logic, High CMR Optocoupler for Intelligent
Power Modules and IGBT/MOSFET Gate Drive
Data Sheet
CAUTION: It is advised that normal static precautions be taken in handling and assembly
of this component to prevent damage and/or degradation which may be induced by ESD.
Features
• Inverted output type (totem pole output)
• Performance Specied for Common IPM Applications
Over Industrial Temperature Range.
• Short Maximum Propagation Delays
• Minimized Pulse Width Distortion (PWD)
• Very High Common Mode Rejection (CMR)
• Hysteresis
• Available in Stretched SO-6 Package.
• Package Clearance/Creepage at 8 mm (ACPL-W481)
• Safety Approval: (pending)
– UL Recognized with 3750 V
rms
(5000 Vrms for
ACPL-W481) for 1 minute per UL1577.
– CSA Approved.
– IEC/EN/DIN EN 60747-5-5 Approved with V
IORM
=
891 V
peak
for ACPL-P481 and V
IORM
= 1140 V
peak
for
ACPL-W481, under option 060.
Specications
• Wide Operating Temperature Range: –40°C to 100°C.
• Maximum Propagation Delay t
PHL
/ t
PLH
= 350 ns
• Maximum Pulse Width Distortion (PWD) = 250 ns.
• Propagation Delay Dierence: Min. –100 ns, Max. 250 ns
• Wide Operating V
CC
Range: 4.5 V to 20 V
• 20 kV/µs Minimum Common Mode Rejection (CMR) at
V
CM
= 1000 V.
Truth Table (Positive Logic)
LED V
O
ON LOW
OFF HIGH
Description
The high-speed ACPL-P481/W481 optocoupler contains
a GaAsP LED, photo detector and a Schmitt trigger that
eliminates the need for external waveform conditioning
circuits.
The totem pole output eliminates the need for a pull-up
resistor. An Intelligent Power Module, Power MOSFET or
IGBT can be driven directly.
Propagation delay dierence between devices has been
minimized to maximize inverter eciency through
reduced switching dead time.
Applications
• IPM Interface Isolation
• Isolated IGBT/MOSFET Gate Drive
• AC and Brushless DC Motor Drives
• Industrial Inverters
• General Digital Isolation
Functional Diagram
Note: A 0.1 µF bypass capacitor must be connected between pins 4 and 6.
Ground
V
CC
Anode
N.C.
Cathode
V
O
61
52
43
SHIELD