RP20-2405SAW

20 Watt
Single &
Dual Output
Features
Regulated
Converters
Wide 4:1 Input Voltage Range
1.6kVDC Isolation
UL Certified
Efficiency up to 90%
Six-Sided Continuous Shield
No Minimum Load
PD-1
REV.: 2/2017www.recom-power.com
DC/DC Converter
3
Y
E
A
R
w
a
r
r
a
n
t
y
3
Description
The RP20-AW series are ultraminiature wide input voltage range power DC/DC converters in a case
half the size of industry standard 20W converters. Despite their small size, the RP20-AW converters are
fully specified devices with output currents up to 4.5 Amps, up to 90% efficiency, no minimum load,
1600VDC isolation, a built-in Class A EMC filter and low ripple/noise figures. The outputs are also fully
protected against short circuits, overcurrent and overvoltage. The no load input current is particularly
low (only 4mA/6mA). The RP20-AW series will find many uses in applications where board space and/
or board height is at a premium or in battery-powered systems where standby current is important.
E196683
RP20-AW
Selection Guide
Part Number Input Output Output Input
(1)
Efficiency
(1)
Max. Capacitive
Voltage Range Voltage Current Current typ. Load
(2)
[VDC] [VDC] [mA] [mA] [%] [µF]
RP20-243.3SAW
(3,4)
9-36 3.3 4500 695 89 7000
RP20-2405SAW
(3,4)
9-36 5 4000 936 89 5000
RP20-2412SAW
(3,4)
9-36 12 1670 938 89 850
RP20-2415SAW
(3,4)
9-36 15 1330 934 89 700
RP20-483.3SAW
(3,4)
18-75 3.3 4500 356 87 7000
RP20-4805SAW
(3,4)
18-75 5 4000 468 89 5000
RP20-4812SAW
(3,4)
18-75 12 1670 469 89 850
RP20-4815SAW
(3,4)
18-75 15 1330 462 90 700
RP20-2412DAW
(3,4)
9-36 ±12 ±833 936 89 ±500
RP20-2415DAW
(3,4)
9-36 ±15 ±667 926 90 ±350
RP20-4812DAW
(3,4)
18-75 ±12 ±833 468 89 ±500
RP20-4815DAW
(3,4)
18-75 ±15 ±667 463 90 ±350
UL60950-1 Certified
Model Numbering
Ordering Examples
RP20-2405SAW/P = 24V 4:1 Input, 5V Output, Positive Logic CTRL pin and Trim pin fitted.
RP20-483.3SAW-HC = 48V 4:1 Input, 3.3V Output, Premounted Heat-sink, no Trim or CTRL pins.
(trim function is only available for single output with /P or /N suffix)
Input Voltage
Output Voltage
Single or Dual
RP20-__ __ _AW/_ _
Package
(5)
Control Logic
(4)
Notes:
Note3: standard part is without suffixes CTRL & Trim pin aren’t fitted
add suffix “P” for CTRL function with positive logic (1=ON, 0=OFF), including trim pin
add suffix “N” for CTRL function with negative logic (0=ON, 1=OFF), including trim pin
Note4: add suffix -HC for premounted Heat-sink and clips
Notes:
Note1: Values at nominal input voltage and full load
Note2: Test by minimum Vin and constant resistor load.
BASIC CHARACTERISTICS
Parameter Condition Min. Typ. Max.
Input Voltage Range
nom. Vin = 24V
nom. Vin = 48V
9VDC
18VDc
24VDC
48VDC
36VDC
75VDC
Under Voltage Lockout (UVLO)
Vin = 24V
DC-DC ON
DC-DC OFF 8VDC
9VDC
Vin = 48V
DC-DC ON
DC-DC OFF 16VDC
18VDC
Input Filter Pi-Type
Input Reflected Ripple Current
(5)
nominal Vin and full load 30mAp-p
Input Surge Voltage
Vin = 24V, 100ms max.
Vin = 48V, 100ms max.
50VDC
100VDC
Start-up time
Power up
Remote ON/OFF
30ms
30ms
Operating Frequency Range
3.3Vout, 5Vout
Others
248kHz
297kHz
275kHz
330kHz
303kHz
363kHz
Minimum Load 0%
Ripple and Noise
measured by 20Mhz bandwidth
with 1µF M/C X7R and a 10µF T/C
Single 75mVp-p
measured by 20Mhz bandwidth
with 1µF M/C X7R and 10µF T/C for
each output
Dual 100mVp-p
Remote ON/OFF
(6)
Positive Logic
DC-DC ON
DC-DC OFF
Open or 3.0V < Vr < 15V
Short or 0V < Vr < 1.2V
Negative Logic
DC-DC ON
DC-DC OFF
Short or 0V < Vr < 1.2V
Open or 3.0V < Vr < 15V
Input current of Remote pin (CTRL)
Negative Logic DC-DC OFF 2mA
Positive Logic DC-DC ON -0.5mA 1mA
continued on next page
PD-2
REV.: 2/2017 www.recom-power.com
DC/DC Converter
RP20-AW
Series
Specifications measured at Ta = 25°C, nominal input voltage, full load otherwise noted
Notes:
Note5: Simulated source impedance of 12µH. 12µH inductor in series with +Vin.
Efficiency vs. Output Current Efficiency vs. Input Voltage
Efficiency [%]
Input Voltage [VDC]
9
65
70
75
80
85
95
15 18 24 30 3612 21 27 33
90
9Vin
24Vin
36Vin
Efficiency [%]
Output Current [%]
10
45
40
50
55
60
65
70
75
90
95
20 40 60 80 10030 50 70 90
80
85
RP20-2405SAW
DC/DC Converter
Specifications measured at Ta = 25°C, nominal input voltage, full load otherwise noted
REGULATIONS
Parameter Condition Value
Output Voltage Accuracy ±1%
Output Trimming Single ±10%
Line Voltage Regulation
Single
Dual
±0.2%
±0.5%
Load Voltage Regulation
0% load to 100% load
Single
Dual
±0.2%
±1.0%
10% load to 100% load
Single
Dual
±0.1%
±0.8%
Cross Regulation asymmetrical 25%<>100% load ±5%
Transient Response recovery time 25% load step change 250µs typ.
continued on next page
RP20-AW
Series
PD-3
REV.: 2/2017www.recom-power.com
Efficiency vs. Output Current
Efficiency vs. Input Voltage
Efficiency [%]
Input Voltage [VDC]
18
65
70
75
80
85
95
30 36 48 60 66 7524 42 54 72
90
36Vin
48Vin
75Vin
Efficiency [%]
Output Current [%]
10
40
45
50
55
60
65
75
70
90
95
20 40 60 80 10030 50 70 90
80
85
RP20-4805SAW
External Output Trimming
Trim up 1 2 3 4 5 6 7 8 9 10 %
Vout = 3.333 3.366 3.399 3.432 3.465 3.498 3.531 3.564 3.597 3.63 Volts
R
U
= 57.93 26.16 15.58 10.28 7.11 4.99 3.48 2.34 1.46 0.75 kOhms
Trim down 1 2 3 4 5 6 7 8 9 10 %
Vout = 3.267 3.234 3.201 3.168 3.135 3.102 3.069 3.036 3.003 2.97 Volts
R
D
= 69.47 31.23 18.49 12.12 8.29 5.74 3.92 2.56 1.50 0.65 kOhms
RP20-xx3.3SAW
Output Voltage Trimming
Single output Powerline converters offer the feature of trimming the output voltage over a certain range around the nominal value by using external
trim resistors. No general equation can be given for calculating the trim resistors, but the following trimtables give typical values for chosing these
trimming resistors. If voltages between the given trim points are required, extrapolate between the two nearest given values to work out the resistor
required or use a variable resistor to set the output voltage. Output can be externally trimmed by using the method shown below.
R
U
6
5
R
D
5
4
Trim up Trim down

RP20-2405SAW

Mfr. #:
Manufacturer:
RECOM Power
Description:
Isolated DC/DC Converters 20W DC/DC 1.6kV REG 18-36Vin 5Vout
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union