Description
Features
Technical Specifications
• Non-Isolated
• High Efficiency Topology
• Excellent Transient Response
• Sense and Power OK (SIE Model Only)
• Surface-Mount Construction
• Voltage Trim
• Vertical or Horizontal Mounting
• Water Washable
SIP/SIE500 DC-DC Series Data Sheet
Non-Isolated, 20 Watts
Page 1 of 2
REV. MAY 07, 2004
SIP/SIE non-isolated step-down DC-DC converters deliver high efficiency and excellent transient response in an
industry-standard SIP package. The SIP/SIE Series has output voltages ranging from 1.2 to 3.3V and up to 6 amps of
output current. The SIE model has power OK and remote sense pins for added flexibility and improved point-of-load
regulation. The SIP/SIE Series is available for vertical or horizontal mounting. The SIP/SIE Series uses 100% surface-
mount construction for maximum reliability and features over seven million hours MTBF.
Voltage Range
5 VDC Nominal 4.5 - 5.5 VDC
Input
Setpoint Accuracy ±1%
Line Regulation V
in
Min. - V
in
Max., I
out
Rated 1% V
out
Load Regulation I
out
Min.- I
out
Max., V
in
Nom. 1% V
out
Ripple and Noise, DC - 20 MHz 50 mV Pk-Pk
Remote Sense Headroom 0.25 V
Current Limit Protection Type Foldback
Current Limit Threshold Range, % of I
out
Rated 120% to 180%
Short Circuit Protection Type Continuous
Power Good Signal (SIE model only);
Asserts “High” When V
out
is Between the Following Thresholds:
Lower Sense Threshold, % Vsetpoint -16% to -10%
Upper Sense Threshold, % Vsetpoint +10% to +16%
Power Good Signal Reference Common Ground
V
out
Ramp Up Rate, Minimum 0.5V/ms
Output
Remote Shutdown Negative Logic
Switching Frequency 330 kHz
Temperature Coefficient 0.03%/°C
Ambient Operating Temperature 0 to +55°C
Minimum Required Airflow 200 LFM
Storage Range -25 to +120°C
Humidity Max., Non-Condensing 95%
Vibration, 3 Axes, 5 Min Each 5 g, 10 - 55 Hz
MTBF
†
(Bellcore TR-NWT-000332) 7.1 x 10
6
hrs
Safety UL, cUL, TUV
Weight (approx.) 0.25 oz
General
Efficiency vs. Load
Notes
†
MTBF predictions may vary slightly from model to model.
Specifications typically at 25°C, normal line, and full load, unless otherwise
stated.
Soldering Conditions: I/O pins, 260°C, ten seconds; fully compatible with
commercial wave-soldering equipment.
Safety: Agency approvals may vary from model to model. Please consult
factory for specific model information.
Units are water-washable and fully compatible with commercial spray or
immersion post wave-solder washing equipment.
NUCLEAR AND MEDICAL APPLICATIONS - Power-One products are not authorized for use as critical components in life support systems,
equipment used in hazardous environments, or nuclear control systems without the express written consent of the respective divisional president
of Power-One, Inc.
TECHNICAL REVISIONS - The appearance of products, including safety agency certifications pictured on labels, may change depending on the
date manufactured. Specifications are subject to change without notice.