PI5C33X257
12 Channel, 2:1 Mux/DeMux Bus Switch
2
PS8114C 11/03/06
Storage Temperature ............................................................ –65°C to +150°C
Ambient Temperature with Power Applied ...........................–40°C to +85°C
Supply Voltage to Ground Potential (Inputs & Vcc Only) ..... –0.5V to +7.0V
Supply Voltage to Ground Potential (Outputs & D/O Only) ..–0.5V to +7.0V
DC Input Voltage ....................................................................–0.5V to +7.0V
DC Output Current.............................................................................. 120 mA
Power Dissipation ................................................................................... 0.5W
Note:
Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the device.
This is a stress rating only and functional operation of the
device at these or any other conditions above those indi-
cated in the operational sections of this specication is not
implied. Exposure to absolute maximum rating conditions
for extended periods may affect reliability.
Capacitance (TA = 25°C, f = 1 MHz)
Parameters
(5)
Description Test Conditions Max. Units
CIN Input Capacitance VIN = 0V 6 pF
COFF In/Yn Capacitance, Switch Off VIN = 0V 6 pF
CON In/Yn Capacitance, Switch On VIN = 0V 14 pF
Product Pin Description
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Pin Name Description
IAn-ILn Data Inputs
S Select Inputs
En Enable
YA-YL Data Outputs
GND Ground
Vcc Power
Notes:
1. For Max. or Min. conditions, use appropriate value specied under Electrical Characteristics for the applicable device type.
2. Typical values are at Vcc = 5.0V, TA = 25°C ambient and maximum loading.
3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.
4. Measured by the voltage drop between I and Y pin at indicated current through the switch. ON resistance is determined by the lower of the volt-
ages on the two (I,Y) pins.
Notes:
5. This parameter is determined by device characterization but is not production tested.
DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC = 5V ±5%)
Parameters Description Test Conditions
(1)
Min. Typ
(2)
Max. Units
VIH Input HIGH Voltage Guaranteed Logic HIGH Level 2.0 V
VIL Input LOW Voltage Guaranteed Logic LOW Level –0.5 0.8 V
IIH Input HIGH Current VCC = Max., VIN = VCC ±1 ΜA
IIL Input LOW Current VCC = Max., VIN = GND ±1 ΜA
IOZH High Impedance Output Current 0 ≤ I, Y ≤ VCC ±1 ΜA
VIK Clamp Diode Voltage VCC = Min., IIN = –18 mA –0.7 –1.2 V
IOS Short Circuit Current
(3)
I (Y) = 0V, Y (I) = VCC 100 mA
VH Input Hysteresis at Control Pins 150 mV
RON Switch On Resistance
(4)
VCC = Min., VIN = 0.0V, ION = 48 mA 5 7 ohm
VCC = Min., VIN = 2.4V, ION = 15 mA 10 15
