3
AT29LV512
0177M–05/02
Any attempt to write to the device without the 3-byte command sequence will start the
internal write timers. No data will be written to the device; however, for the duration of
t
WC
, a read operation will effectively be a polling operation.
After the software data protection’s 3-byte command code is given, a byte load is per-
formed by applying a low pulse on the WE
or CE input with CE or WE low (respectively)
and OE
high. The address is latched on the falling edge of CE or WE, whichever occurs
last. The data is latched by the first rising edge of CE
or WE.
The 128 bytes of data must be loaded into each sector. Any byte that is not loaded dur-
ing the programming of its sector will be erased to read FFh. Once the bytes of a sector
are loaded into the device, they are simultaneously programmed during the internal pro-
gramming period. After the first data byte has been loaded into the device, successive
bytes are entered in the same manner. Each new byte to be programmed must have its
high-to-low transition on WE
(or CE) within 150 µs of the low-to-high transition of WE (or
CE
) of the preceding byte. If a high-to-low transition is not detected within 150 µs of the
last low-to-high transition, the load period will end and the internal programming period
will start. A7 to A15 specify the sector address. The sector address must be valid during
each high-to-low transition of WE
(or CE). A0 to A6 specify the byte address within the
sector. The bytes may be loaded in any order; sequential loading is not required. Once a
programming operation has been initiated, and for the duration of t
WC
, a read operation
will effectively be a polling operation.
HARDWARE DATA PROTECTION: Hardware features protect against inadvertent
programs to the AT29LV512 in the following ways: (a) V
CC
sense – if V
CC
is below 1.8V
(typical), the program function is inhibited; (b) V
CC
power on delay – once V
CC
has
reached the V
CC
sense level, the device will automatically time out 10 ms (typical)
before programming; (c) Program inhibit – holding any one of OE
low, CE high or WE
high inhibits program cycles; and (d) Noise filter – pulses of less than 15 ns (typical) on
the WE
or CE inputs will not initiate a program cycle.
INPUT LEVELS: Whileoperatingwitha3.3V±10% power supply, the address inputs
and control inputs (OE
,CEand WE) may be driven from 0 to 5.5V without adversely
affecting the operation of the device. The I/O lines can only be driven from 0 to 3.6 volts.
PRODUCT IDENTIFICATION: The product identification mode identifies the device
and manufacturer as Atmel. It may be accessed by hardware or software operation. The
hardware operation mode can be used by an external programmer to identify the correct
programming algorithm for the Atmel product. In addition, users may wish to use the
software product identification mode to identify the part (i.e., using the device code), and
have the system software use the appropriate sector size for program operations. In this
manner, the user can have a common board design for 256K to 4-megabit densities
and, with each density’s sector size in a memory map, have the system software apply
the appropriate sector size.
For details, see Operating Modes (for hardware operation) or Software Product Identifi-
cation. The manufacturer and device code is the same for both modes.
DATA
POLLING: The AT29LV512 features DATA polling to indicate the end of a pro-
gram cycle. During a program cycle an attempted read of the last byte loaded will result
in the complement of the loaded data on I/O7. Once the program cycle has been com-
pleted, true data is valid on all outputs and the next cycle may begin. DATA
polling may
begin at any time during the program cycle.
