108-9039
3.4. Perform ance and Test Description
Product is designed to m eet the electrical, m echanical and environm ental perform ance requirem ents
specified in Figure 1. All tests are perform ed at am bient tem perature unless otherwise specified.
3.5. Test Requirem ents and Procedures Summ ary
Test Description Requirem ent Procedure
Exam ination of product. Meets requirem ents of product
drawing.
Visual, dim ensional and functional
per applicable quality inspection
plan.
Termination resistance, dry circuit. 10 milliohm s maximum . TE Spec 109-6-1.
Subject mated contacts assem bled
in housing to 50 m v open circuit at
100 m a m axim um .
See Figure 3.
Dielectric withstanding voltage. Test Voltage Centerline
RMS Spacing
1000 .100
1500 .125
5 milliam peres m axim um leakage.
TE Spec 109-29-1.
Test between adjacent contacts of
unm ated connector assem blies.
Insulation resistance. 5000 megohm s m inim um . TE Spec 109-28-4.
Test between adjacent contacts of
unm ated connector assem blies.
MECHANICAL
Vibration, random . No discontinuities greater than 1
microsecond.
TE Spec 109-21-5, Condition C.
Subject mated connectors to 9 G's
rms for 3 minutes.
See Figure 4.
Physical shock. No discontinuities greater than 1
microsecond.
TE Spec 109-26-1.
Subject mated connectors to 50
G's half-sine shock pulses of 11
milliseconds duration. 3 shocks in
each direction applied along 3
mutually perpendicular planes, 18
total shocks.
See Figure 4.
Mating force. 19 ounces maxim um per contact
pair.
TE Spec 109-42, Condition A.
Measure force necessary to m ate
connector with daughter card from
point of initial contact using free
floating fixtures at a rate of .5 inch
per m inute.
Calculate force per contact.
Unm ating force. 1.25 ounces m inim um per contact
pair.
TE Spec 109-42, Condition A.
Measure force necessary to
unm ate assem blies at a rate of .5
inch per m inute.
Calculate force per contact.
Figure 1 (continued)
Rev M 2 of 7
