SPECIFICATION CONTROL DRAWING
TE Connectivity
300 Constitutional Drive
Menlo Park, CA 94025 USA
TITLE :
Solder Sleeve One Step
Wire Terminator Low Temperature
UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MILLIMETERS.
INCHES DIMENSIONS ARE BETWEEN BRACKETS.
DOCUMENT NO.: CWT-150X
TOLERANCES:
0.00 N/A
0.0 N/A
0 N/A
ANGLES: N/A
ROUGHNESS IN
MICRON
TE Connectivity reserves the right to amend
this drawing at any time. Users should evaluate
the suitability of the product for their
application.
DATE:
15-Apr-11
DOC ISSUE:
7
DRAWN BY:
M. FORONDA
CAGE CODE:
06090
REPLACES:
D980899
DCR NUMBER:
D010038
PROD. REV.:
SEE TABLE
SCALE:
None
SIZE:
A
SHEET:
1 of 1
Print Date: 9-May-11 If this document is printed it becomes uncontrolled. Check with the web for the latest revision
Product Revision Product Dimensions Wire and Pin Dimensions
Product
Name
øA
min
L
min
øB
max
øC
min
øC
max
øD
max
CWT-1501 A 1.5 (0.060) 1.5 (0.060) 2.0 (0.080) 0.9 (0.035) 1.5 (0.060) 0.6 (0.025)
CWT-1502 A 2.3 (0.090) 2.3 (0.090) 2.9 (0.115) 1.1 (0.045) 2.3 (0.090) 0.9 (0.035)
CWT-1503 A 2.8 (0.110) 2.8 (0.110) 3.2 (0.125) 1.6 (0.065) 2.8 (0.110) 1.2 (0.045)
CWT-1504 A 3.8 (0.150) 3.8 (0.150) 4.5 (0.180) 1.8 (0.070) 3.8 (0.150) 1.5 (0.060)
MATERIALS
1. INSULATION SLEEVE: Heat-shrinkable, transparent clear, radiation cross-linked modified polyolefin.
2. SOLDER PREFORM WITH FLUX:
SOLDER: TYPE Cd18 per ANSI-J-STD-006.
FLUX: TYPE ROM1 per ANSI-J-STD-004.
APPLICATION
1. These controlled soldering devices are designed for termination of a wire to the lead of electrical component or to the terminal
of a connector.
2. Temperature range: -55C to +125C.
3. For installation procedure and application equipment, consult RPIP-824-00
For best results, prepare the cable as shown:
Stripping Dimensions
1) Wires smaller than AWG 18:
E: 6.5±0.5
F: 8.0±0.5
2) Wires AWG 18 and larger:
E: 9.5±0.5
F: 11.0±0.5
