OMO ElectronicOMO Electronic
Expand menu
Hello, Sign inMy Account
0 Cart

MGJ6D241505DC

P1-P3P4-P6P7-P9P10-P12P13-P15P16-P16
MGJ6 SIP/DIP Series
5.7kVDC Isolated 6W Gate Drive SIP/DIP DC/DC Converters
KDC_MGJ6C-SCDC.B01 Page 4 of 16
www.murata-ps.com/support
INPUT CHARACTERISTICS
Parameter Conditions Min. Typ. Max. Units
Voltage range
5V input types 4.5 5 9
V
12V input types 9 12 18
24V input types 18 24 36
Under voltage lock out
Turn on threshold MGJ6D05 4.1
V
Turn off threshold MGJ6D05 3.0
Turn on threshold MGJ6D12 8.1
Turn off threshold MGJ6D12 7.5
Turn on threshold MGJ6D24 16.7
Turn off threshold MGJ6D24 16.3
Input ripple current
5V input types 40
mA
p-p
12V input types 40
24V input types 24
OUTPUT CHARACTERISTICS
Parameter Conditions Min. Typ. Max. Units
Minimum load Below 10% load, 5V and 15V outputs are clamped to 6V and 17V respectively 10 %
Voltage set point accuracy
Output 1 ±3 %
Output 2 ±5 %
Line regulation Low line to high line 2 %
Total Regulation 15 %
Transient response
Peak deviation (50-100% & 100-50% load swing) %V
out
Settling time ms
GENERAL CHARACTERISTICS
Parameter Conditions Min. Typ. Max. Units
Switching frequency 100 kHz
ISOLATION CHARACTERISTICS
Parameter Conditions Min. Typ. Max. Units
Isolation test voltage
Production tested for 1 second 5700
VDC
Qualification tested for 1 minute 5700
Resistance Viso = 1kVDC 100 GΩ
Continuous barrier withstand voltage Non-safety barrier application 3000 VDC
ABSOLUTE MAXIMUM RATINGS
Short-circuit protection Continuous
Lead temperature 1.0mm from case for 10 seconds (to JEDEC JESD22-B106 ISS C) 260°C
Input voltage, MGJ6 5V input types 12V
Input voltage, MGJ6 12V input types 20V
Input voltage, MGJ6 24V input types 40V
TEMPERATURE CHARACTERISTICS
Parameter Conditions Min. Typ. Max. Units
Operation See derating graphs -40 105
°CStorage -50 125
Product temperature rise above ambient 100% Load, Nom V
IN, Still Air 30
RoHS COMPLIANCE, MSL AND PSL INFORMATION
This series is compatible with RoHS soldering systems with a peak wave solder temperature of 260ºC for 10 seconds.
The pin termination finish on this product series is Tin with Nickel Preplate. The series is backward compatible with Sn/Pb
soldering systems.
MGJ6 SIP/DIP Series
5.7kVDC Isolated 6W Gate Drive SIP/DIP DC/DC Converters
KDC_MGJ6C-SCDC.B01 Page 5 of 16
www.murata-ps.com/support
APPLICATION NOTES
Start-up times
Part No.
Start-up times
ms
MGJ6D051510DC 15
MGJ6D121510DC 15
MGJ6D241510DC 15
MGJ6D052005DC 15
MGJ6D122005DC 15
MGJ6D242005DC 15
MGJ6D051505DC 15
MGJ6D121505DC 15
MGJ6D241505DC 15
MGJ6D051510SC 15
MGJ6D121510SC 15
MGJ6D241510SC 15
MGJ6D052005SC 15
MGJ6D122005SC 15
MGJ6D242005SC 15
MGJ6D051505SC 15
MGJ6D121505SC 15
MGJ6D241505SC 15
Disable/Frequency synchronisation
Min Typ Max Units
Disable/Synch
1
Pull Down Current
0.5 mA
Input High 2 5 V
Input Low 0 0.8 V
Synchronisation
Frequency Range 90 100 110 kHz
Duty Cycle
25 75 %
Typical start up times for this series, with no additional output capacitance are:
Output capacitance must not exceed:
Please refer to application notes for further information.
Output Voltage
Maximum output
capacitance
VµF
-5 470
-10 220
15 220
20 150
The Disable/Synchronization pin has three modes:
1. When a dc logic low voltage is applied to this pin the MGJ6 is disabled and enters a low quiescent current sleep mode.
2. When this pin is left floating or a dc logic high (CMOS/TTL compatible) voltage is applied the MGJ6 is enabled and operates at the programmed frequency of 100kHz.
3. When a square wave of between 90kHz and 110kHz is applied to this pin, the switcher operates at the same frequency as the square wave. The falling edge of the
square wave corresponds to the start of the switching cycle. If the signal is slower than 25Hz, it will be interpreted as enabling and disabling the part. If the MGJ6 is
disabled, it must be disabled for 7 clock cycles before being re-enabled.
MGJ6 SIP/DIP Series
5.7kVDC Isolated 6W Gate Drive SIP/DIP DC/DC Converters
KDC_MGJ6C-SCDC.B01 Page 6 of 16
www.murata-ps.com/support
APPLICATION NOTES(Continued)
Output configurations for power switches
Terminal
Pin
(SIP)
Pin
(DIP)
IGBT SIC MOSFET
15V Output 3 5
+15V
0.24A
+20V
0.24A
+15V
0.3A
15V Return
5VA Output
6 4 0V No connection 0V
5VA Return
5VB Output
5 3 No connection 0V
-5V
0.3A
5VB Return 4 2
-10V
0.24A
-5V
0.24A
No connection
P1-P3P4-P6P7-P9P10-P12P13-P15P16-P16

MGJ6D241505DC

Mfr. #:
Buy MGJ6D241505DC
Manufacturer:
Description:
DC/DC 6W DIP 12-15/5V
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet