114 - 6061
Rev D2 of 14
2. REFERENCE MATERIAL
2.1. Revision Summary
Revisions to this application specification include:
S Changed company logo
2.2. Customer Assistance
Reference Product Base Part Number 787311 and Product Code 7427 are representative of CHAMP .050
Series I Blindmate SCA--2. Use of these numbers will identify the product line and expedite your inquiries
through a service network established to help you obtain product and tooling information. Such information can
be obtained through a local Representative or , after purchase, by calling PRODUCT INFORMATION at the
number at the bottom of page 1.
2.3. Drawings
Customer Drawings for product part numbers are available from the service network. If there is a conflict
between the information contained in the Customer Drawings and this specification or with any other technical
documentation supplied, call PRODUCT INFORMATION at the number at the bottom of page 1.
2.4. Manuals
Manual 402--40 can be used as a guide to soldering. This manual provides information on various flux types
and characteristics with the commercial designation and flux removal procedures. A checklist is included in the
manual as a guide for information on soldering problems.
2.5. Specifications
Product Specification 108--1548 provides product performance and test information.
2.6. Instructional Material
Instruction Sheets (408--series) provide product assembly instructions or tooling setup and operation
procedures and Customer Manuals (409--series) provide machine setup and operating procedures.
Documents available which pertain to this product are:
408--6927 Design Recommendations for PC Board Support Fixture
408--4328 Seating Tool Assemblies 1320142--[ ] and 356198--[ ]
408--9027 Adapter Kit for Greenerd Frame Assembly
409--5626 SM--3 Machine 814700--2
3. REQUIREMENTS
3.1. Storage
A. Ultraviolet Light
Prolonged exposure to ultraviolet light may deteriorate the chemical composition used in the housings.
B. Shelf Life
The plugs and receptacles should remain in the shipping containers until ready for use to prevent
deformation to the plugs and receptacles. The plugs and receptacles should be used on a first in, first out
basis to avoid storage contamination that could adversely affect signal transmissions.
C. Chemical Exposure
Do not store the plugs and receptacles near any chemicals listed below as they may cause stress
corrosion cracking in the contacts.
Alkalies Ammonia Citrates Phosphates Citrates Sulfur Compounds
Amines Carbonates Nitrites Sulfur Nitrites Tartrates
Greenerd is a trademark.