iSensor™ Digital Gyroscope
Evaluation Board
Preliminary Technical Data
ADIS16060/PCB
Rev. PrA
Evaluation boards are only intended for device evaluation and not for production purposes.
Evaluation boards as supplied “as is” and without warranties of any kind, express, implied, or
statutory including, but not limited to, any implied warranty of merchantability or fitness for a
particular purpose. No license is granted by implication or otherwise under any patents or other
intellectual property by application or use of evaluation boards. Information furnished by Analog
Devices is believed to be accurate and reliable. However, no responsibility is assumed by Analog
Devices for its use, nor for any infringements of patents or other rights of third parties that may result
from its use. Analog Devices reserves the right to change devices or specifications at any time
without notice. Trademarks and registered trademarks are the property of their respective owners.
Evaluation boards are not authorized to be used in life support devices or systems.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700 www.analog.com
Fax: 781.461.3113 ©2008 Analog Devices, Inc. All rights reserved.
GENERAL DESCRIPTION
The ADIS16060/PCB are simple evaluation boards that provide
convenient access to the ADIS16060 family of products, using a
standard 2 mm, 2 × 6, connector interface. These connectors
can be accessed using a variety of cable options, including
standard 1 mm ribbon cables. The ADIS16060/PCB is designed
to be evaluated in an existing digital platform (such as MCU,
DSP, FPGA, PLD) or as part of the ADISEVAL system. Four
mounting holes (sized for 2-56 or 2 mm screws) have been
provided to secure the board during evaluation. Note: The
ADIS16060/PCBZ will not work with the ADISEVAL/USBZ at
this time.
CIRCUIT DESCRIPTION
The schematic, layout, and parts list for the ADIS16060/PCB
can be found in
The ADIS16060’s digitized outputs can be accessed using the
4-wire serial port interface (SPI) signals on J1: SCLK, CS, DOUT,
and DIN. For specific information on using the ADIS16060 SPI
interface, refer to the ADIS16060 data sheet. Auxiliary functions,
such as the 12-bit ADC input, can be accessed using J2. C1
provides additional power supply filtering but is generally not
required.
Table 1. Parts List
Reference Designator Part Description
U1 ADIS16060BCCZ
1
J1, J2 12-pin, dual row, 2 mm connector
C1, C4 Power supply filtering, not installed
C2 Reference filtering, not installed
C3 Bandwidth limiting, 0.015μF (80Hz)
1
x = 0, 1, 2, 3, 4 or 9, y = B or C
SPECIAL NOTES ON HANDLING
Note that the ADIS16060/PCB is not reverse-polarity protected.
Reversing the power supply or applying inappropriate voltages
(that is, voltages outside the Absolute Maximum Ratings in the
ADIS16060 data sheet) to any pin may damage the ADIS16060/PCB.
Table 2. Power Supply Levels
Parameter Range
V
CC
4.75 V to 5.25 V
Figure 1. J1 Pin Assignments
NOTE: Pin 12 is not tied to pins 10 and 11, but is required for
normal operation. Either connect them with a solder
bridge or bring another wire to pin 12 from the power
supply.
Figure 2. ADIS16060/PCB Layout (Top View)
