Additive Jitter at 2.5 V*
Output Frequency (MHz) Jitter
Measurement
Filter
Typical
(f
s)
Notes
1 125 12 kHz - 20 MHz 120
2 212.5 12 kHz - 20 MHz 102
3 311.04 12 kHz - 20 MHz 88
4 425 12 kHz - 20 MHz 91
5 500 12 kHz - 20 MHz 77
6 622.08 12 kHz - 20 MHz 78
7 750 12 kHz - 20 MHz 78
ZL40213 Data Sheet
17
Microsemi Corporation
5.0 Performance Characterization
*The values in this table were taken with a slew rate of approximately 0.8 V/ns.
Additive Jitter at 3.3 V*
Output Frequency (MHz) Jitter
Measurement
Filter
Typical
(f
s)
Notes
1 125 12 kHz - 20 MHz 123
2 212.5 12 kHz - 20 MHz 104
3 311.04 12 kHz - 20 MHz 92
4 425 12 kHz - 20 MHz 94
5 500 12 kHz - 20 MHz 78
6 622.08 12 kHz - 20 MHz 79
7 750 12 kHz - 20 MHz 80
*The values in this table were taken with a slew rate of approximately 0.8 V/ns.
* The values in this table are the additive periodic jitter caused by an interfering tone typically caused by a switching power supply. For this test,
measurements were taken over the full temperature and voltage range for V
DD
= 3.3 V. The magnitude of the interfering tone is measured at the
DUT.
Additive jitter in the presence of power supply noise*
Carrier
frequency
Parameter Typical Units Notes
125 25 mV
at 100 kHz
38 fs RMS
750 25 mV
at 100 kHz
50 fs RMS