Absolute maximum ratings and operating
conditions
2 Absolute maximum ratings and operating conditions
Table 1: Absolute maximum ratings
Symbol Parameter Value Unit
V
CC
+
Supply voltage ±16 to 32
V V
in
Input voltage -0.3 to 32
V
id
Differential input voltage ±32
Output short-circuit duration
Infinite
I
in
Input current
50 mA
T
stg
Storage temperature range -65 to 150
°C
T
j
Maximum junction temperature 150
R
thja
Thermal resistance junction-to-ambient
250
°C/W
R
thjc
Thermal resistance junction-to-case
81
ESD
HBM: human body model
500
V
MM: machine model
200
CDM: charged device model
1000
Notes:
(1)
Short-circuits from the output to V
CC
can cause excessive heating if V
CC
> 15 V. The maximum output
current is approximately 40 mA independent of the magnitude of V
CC
.
(2)
This input current only exists when the voltage at any of the input leads is driven negative. It is due to the
collector-base junction of the input PNP transistor becoming forward biased and thereby acting as input diodes
clamps. In addition to this diode action, there is also NPN parasitic action on the IC chip. This transistor action
can cause the output voltages of the op amp to go to the V
CC
voltage level (or to ground for a large overdrive)
for the time during which an input is driven negative. This is not destructive and normal output is restored when
the input voltage goes back above -0.3 V.
(3)
Short-circuits can cause excessive heating. Destructive dissip
ation can result from simultaneous
short-circuits on all amplifiers. All values are typical.
(4)
Human body model: a 100 pF capacitor is charged to the specified voltage, then discharged through a
1.5 kΩ resistor between two pins of the device. This is done for all couples of connected pin combinations
while the other pins are floating.
(5)
Machine model: a 200 pF capacitor is charged to the specified voltage, then discharged directly between two
pins of the device with no external series resistor (internal resistor < 5 Ω). This is done for all couples of
connected pin combinations while the other pins are floating.
(6)
Charged device model: all pins and the package are charged together to the specified voltage and then
discharged directly to ground through only one pin. This is done for all pins.
Table 2: Operating conditions
Symbol Parameter Value Unit
V
CC
Supply voltage 3 to 30
V
V
icm
Input common mode voltage range
(V
CC
+
= 30 V)
T
amb
= 25 °C
0 to (V
CC
+
) - 1.5
T
min
≤ T
amb
≤ T
max
0 to (V
CC
+
) - 2
T
oper
Operating free air temperature range -40 to 125 °C