1
ICM7211AM
4-Digit, LCD Display Driver
The ICM7211AM device is a non-multiplexed four-digit
seven-segment CMOS LCD display decoder-driver.
This device is configured to drive conventional LCD displays
by providing a complete RC oscillator, divider chain,
backplane driver, and 28 segment outputs.
It also has a microprocessor compatible input configuration,
which provides data input latches and Digit Address latches
under control of high-speed Chip Select inputs. These devices
simplify the task of implementing a cost-effective
alphanumeric seven-segment display for microprocessor
systems, without requiring extensive ROM or CPU time for
decoding and display updating.
The ICM7211AM provides the “Code B” output code, i.e.,
0-9, dash, E, H, L, P, blank, but will correctly decode true
BCD to seven-segment decimal outputs.
Features
• Four Digit Non-Multiplexed 7 Segment LCD Display
Outputs with Backplane Driver
• Complete Onboard RC Oscillator to Generate Backplane
Frequency
• Backplane Input/Output Allows Simple Synchronization of
Slave-Devices to a Master
• Provides Data and Digit Address Latches Controlled by
Chip Select Inputs to Provide a Direct High Speed
Processor Interface
• Decodes Binary to Code B (0-9, Dash, E, H, L, P, Blank)
• Pb-Free Plus Anneal Available (RoHS Compliant)
Ordering Information
PART NUMBER PART MARKING
DISPLAY
TYPE
DISPLAY
DECODING
INPUT
INTERFACING
DISPLAY
DRIVE TYPE
TEMP.
RANGE (°C) PACKAGE
PKG.
DWG. #
ICM7211AMlM44 ICM7211AMlM44 LCD Code B Microprocessor Direct Drive -40 to 85 44 Ld MQFP Q44.10x10
ICM7211AMlPL (No
longer available,
recommended
replacement:
ICM7211AMIPLZ)
ICM7211AMlPL LCD Code B Microprocessor Direct Drive -40 to 85 40 Ld PDIP E40.6
ICM7211AMlPLZ
(Note)
ICM7211AMlPLZ LCD Code B Microprocessor Direct Drive -40 to 85 40 Ld PDIP*
(Pb-free)
E40.6
NOTE: Intersil Pb-free plus anneal products employ special Pb-free material sets; molding compounds/die attach materials and 100% matte tin plate
termination finish, which are RoHS compliant and compatible with both SnPb and Pb-free soldering operations. Intersil Pb-free products are MSL
classified at Pb-free peak reflow temperatures that meet or exceed the Pb-free requirements of IPC/JEDEC J STD-020.
*Pb-free PDIPs can be used for through hole wave solder processing only. They are not intended for use in Reflow solder processing applications.
Data Sheet FN3158.8October 22, 2015
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774
| Copyright Intersil Americas LLC 2001, 2004-2006, 2015. All Rights Reserved
Intersil (and design) is a trademark owned by Intersil Corporation or one of its subsidiaries.
All other trademarks mentioned are the property of their respective owners.