CAT25640
www.onsemi.com
6
Pin Description
SI: The serial data input pin accepts op−codes, addresses
and data. In SPI modes (0,0) and (1,1) input data is latched
on the rising edge of the SCK clock input.
SO: The serial data output pin is used to transfer data out of
the device. In SPI modes (0,0) and (1,1) data is shifted out
on the falling edge of the SCK clock.
SCK: The serial clock input pin accepts the clock provided
by the host and used for synchronizing communication
between host and CAT25640.
CS
: The chip select input pin is used to enable/disable the
CAT25640. When CS
is high, the SO output is tri−stated (high
impedance) and the device is in Standby Mode (unless an
internal write operation is in progress). Every communication
session between host and CAT25640 must be preceded by a
high to low transition and concluded with a low to high
transition of the CS
input.
WP: The write protect input pin will allow all write
operations to the device when held high. When WP
pin is
tied low and the WPEN bit in the Status Register (refer to
Status Register description, later in this Data Sheet) is set to
“1”, writing to the Status Register is disabled.
HOLD
: The HOLD input pin is used to pause transmission
between host and CAT25640, without having to retransmit
the entire sequence at a later time. To pause, HOLD
must be
taken low and to resume it must be taken back high, with the
SCK input low during both transitions. When not used for
pausing, the HOLD
input should be tied to V
CC
, either
directly or through a resistor.
Functional Description
The CAT25640 device supports the Serial Peripheral
Interface (SPI) bus protocol, modes (0,0) and (1,1). The
device contains an 8−bit instruction register. The instruction
set and associated op−codes are listed in Table 9.
Reading data stored in the CAT25640 is accomplished by
simply providing the READ command and an address.
Writing to the CAT25640, in addition to a WRITE
command, address and data, also requires enabling the
device for writing by first setting certain bits in a Status
Register, as will be explained later.
After a high to low transition on the CS
input pin, the
CAT25640 will accept any one of the six instruction
op−codes listed in Table 9 and will ignore all other possible
8−bit combinations. The communication protocol follows
the timing from Figure 2.
Table 9. INSTRUCTION SET
Instruction Op−code Operation
WREN 0000 0110 Enable Write Operations
WRDI 0000 0100 Disable Write Operations
RDSR 0000 0101 Read Status Register
WRSR 0000 0001 Write Status Register
READ 0000 0011 Read Data from Memory
WRITE 0000 0010 Write Data to Memory
Figure 2. Synchronous Data Timing
CS
SCK
SI
SO
t
CNH
t
CSS
t
WH
t
WL
t
SU
t
H
HI−Z
VALID
IN
VALID
OUT
t
CSH
t
RI
t
FI
t
V
t
V
t
HO
t
CNS
t
CS
HI−Z
t
DIS
