RL78/G10 CHAPTER 2 ELECTRICAL SPECIFICATIONS
R01DS0207EJ0100 Rev.1.00
Apr 15, 2013
Page 14 of 28
2.3.2 Supply current characteristics
(TA = −40 to +85°C, 2.0 V ≤ VDD ≤ 5.5 V, VSS = 0 V)
Parameter Symbol Conditions MIN. TYP. MAX. Unit
Basic
operation
f
IH = 20 MHz VDD = 3.0 V, 5.0 V 0.91
fIH = 20 MHz VDD = 3.0 V, 5.0 V 1.57 2.04
IDD1
Operating
mode
Normal
operation
f
IH = 5 MHz VDD = 3.0 V, 5.0 V 0.85 1.15
mA
fIH = 20 MHz VDD = 3.0 V, 5.0 V 350 820 IDD2
Note 2
HALT mode
f
IH = 5 MHz VDD = 3.0 V, 5.0 V 290 600
µA
Supply current
Note 1
I
DD3
Note 3
STOP mode VDD = 3.0 V 0.56 2.00 µA
WDT supply current
Note 4
I
WDT fIL = 15 kHz 0.31 µA
VDD = 5.0 V 1.30 1.90
ADC supply current
Note 5
I
ADC
During conversion at the
highest speed
V
DD = 3.0 V 0.50
mA
Notes 1. Total current flowing into V
DD, including the input leakage current flowing when the level of the input pin is
fixed to VDD or VSS. The values below the MAX. column include the peripheral operation current. However,
not including the current flowing into the watchdog timer, A/D converter, I/O port, and on-chip pull-up/pull-
down resistors.
2. During HALT instruction execution by flash memory.
3. When the high-speed on-chip oscillator is stopped.
4. Current flowing only to the watchdog timer (including the operating current of the low-speed on-chip
oscillator). The current value of the RL78 microcontrollers is the sum of I
DD1, IDD2 or IDD3 and IWDT when the
watchdog timer operates.
5. Current flowing only to the A/D converter. The current value of the RL78 microcontrollers is the sum of I
DD1
or IDD2 and IADC when the A/D converter operates in an operation mode or the HALT mode.
Remarks 1. f
IL: Low-speed on-chip oscillator clock frequency
2. fIH: High-speed on-chip oscillator clock frequency
3. Temperature condition of the TYP. value is T
A = 25°C