STANDARD
SIZE
A
5962-88593
COLUMBUS, OHIO 43218-3990
REVISION LEVEL
F
SHEET
3
DSCC FORM 2234
APR 97
1.3 Absolute maximum ratings. 1/
Supply voltage range ..................................................................... ±20 V dc
Input voltage .................................................................................. Supply voltage
Output short-circuit duration .......................................................... Indefinite
Differential input voltage ................................................................ ±30 V dc
Storage temperature range ............................................................ -65°C to +150°C
Lead temperature range (soldering, 60 seconds) .......................... +300°C
Junction temperature (T
J
) .............................................................. +150°C
Thermal resistance, junction-to-case (θ
JC
) ..................................... See MIL-STD-1835
Thermal resistance (θ
JA
):
Case P ....................................................................................... 119°C/W
Case 2 ........................................................................................ 120°C/W
1.4 Recommended operating conditions.
Supply voltage (V
CC
) ...................................................................... ±15 V dc
Source resistance from ground to input terminals (R
S
) .................. 50 Ω
Ambient operating temperature range (T
A
) .................................... -55°C to +125°C
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part
of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the
solicitation or contract.
DEPARTMENT OF DEFENSE SPECIFICATION
MIL-PRF-38535 - Integrated Circuits, Manufacturing, General Specification for.
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-883 - Test Method Standard Microcircuits.
MIL-STD-1835 - Interface Standard Electronic Component Case Outlines.
DEPARTMENT OF DEFENSE HANDBOOKS
MIL-HDBK-103 - List of Standard Microcircuit Drawings.
MIL-HDBK-780 - Standard Microcircuit Drawings.
(Copies of these documents are available online at http://quicksearch.dla.mil/
or from the Standardization Document Order
Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
2.2 Order of precedence. In the event of a conflict between the text of this drawing and the references cited herein, the text
of this drawing takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
________
1/ Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability.