CBTD3384 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2012. All rights reserved.
Product data sheet Rev. 8 — 12 December 2012 4 of 17
NXP Semiconductors
CBTD3384
10-bit level shifting bus switch with 5-bit output enables
7. Limiting values
[1] Stresses beyond those listed may cause permanent damage to the device. These are stress ratings only and functional operation of the
device at these or any other conditions beyond those indicated under Section 8.
is not implied. Exposure to absolute-maximum-rated
conditions for extended periods may affect device reliability.
[2] The input and output negative-voltage ratings may be exceeded if the input and output clamp-current ratings are observed.
8. Recommended operating conditions
9. Static characteristics
Table 4. Limiting values
In accordance with the Absolute Maximum Rating System (IEC 60134).
[1]
T
amb
=
40
C to +85
C, unless otherwise specified.
Symbol Parameter Conditions Min Max Unit
V
CC
supply voltage 0.5 +7.0 V
V
I
input voltage
[2]
0.5 +7.0 V
I
O
output current V
O
<0V - 128 mA
I
IK
input clamping current V
I/O
=0V 50 - mA
T
stg
storage temperature 65 +150 C
Table 5. Operating conditions
All unused control inputs of the device must be held at V
CC
or GND to ensure proper device operation.
Symbol Parameter Conditions Min Typ Max Unit
V
CC
supply voltage 4.5 - 5.5 V
V
IH
HIGH-level input voltage 2.0 - - V
V
IL
LOW-level input voltage - - 0.8 V
T
amb
ambient temperature operating in free air 40 - +85 C
Table 6. Static characteristics
Voltages are referenced to GND (ground = 0 V).
Symbol Parameter Conditions T
amb
= 40 C to +85 C Unit
Min Typ
[1]
Max
V
IK
input clamping voltage V
CC
=4.5V; I
I
= 18 mA - - 1.2 V
I
I
input leakage current V
CC
=5.5V; V
I
= GND or 5.5 V - - 1 A
I
CC
supply current V
CC
=5.5V; I
O
=0mA;
V
I
=V
CC
or GND
--1.5mA
I
CC
additional supply current per input pin; V
CC
= 5.5 V; one input
at 3.4 V, other inputs at V
CC
or GND
[2]
--2.5mA
V
pass
pass voltage see Figure 5 to Figure 9 ---V
C
I
input capacitance control pins; V
I
= 3 V or 0 V - 3.2 - pF
C
io(off)
off-state input/output
capacitance
port off; V
I
= 3 V or 0 V; nOE =V
CC
-6.0-pF
