74LCX245FT
4
9.
9.
9.
9. Absolute Maximum Ratings (Note)
Absolute Maximum Ratings (Note)
Absolute Maximum Ratings (Note)
Absolute Maximum Ratings (Note)
Characteristics
Supply voltage
Input voltage (DIR,OE)
Bus I/O voltage
Input diode current
Output diode current
Output current
Power dissipation
V
CC
/ground current
Storage temperature
Symbol
V
CC
V
IN
V
I/O
I
IK
I
OK
I
OUT
P
D
I
CC
/I
GND
T
stg
Note
(Note 1)
(Note 2)
(Note 3)
Rating
-0.5 to 6.5
-0.5 to 6.5
-0.5 to 6.5
-0.5 to V
CC
+ 0.5
-50
±50
±50
180
±100
-65 to 150
Unit
V
V
V
mA
mA
mA
mW
mA
Note: Exceeding any of the absolute maximum ratings, even briefly, lead to deterioration in IC performance or even
destruction.
Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the
significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even
if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum
ratings and the operating ranges.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook
(“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test report
and estimated failure rate, etc).
Note 1: Output in OFF state.
Note 2: High (H) or Low (L) state. I
OUT
absolute maximum rating must be observed.
Note 3: V
OUT
< GND, V
OUT
> V
CC
10.
10.
10.
10. Operating Ranges (Note)
Operating Ranges (Note)
Operating Ranges (Note)
Operating Ranges (Note)
Characteristics
Supply voltage
Input voltage (DIR,OE)
Bus I/O voltage
Output current
Operating temperature
Input rise and fall times
Symbol
V
CC
V
IN
V
I/O
I
OH
,I
OL
T
opr
dt/dv
Note
(Note 1)
(Note 2)
(Note 3)
(Note 4)
(Note 5)
(Note 6)
Rating
1.65 to 3.6
1.5 to 3.6
0 to 5.5
0 to 5.5
0 to V
CC
±24
±12
-40 to 85
0 to 10
Unit
V
V
V
mA
ns/V
Note: The operating ranges must be maintained to ensure the normal operation of the device.
Unused inputs and bus inputs must be tied to either V
CC
or GND. Please connect both bus inputs and the bus
outputs with V
CC
or GND when the I/O of the bus terminal changes by the function. In this case, please note
that the output is not short-circuited.
Note 1: Data retention only.
Note 2: Output in OFF state.
Note 3: High or low state
Note 4: V
CC
= 3.0 to 3.6 V
Note 5: V
CC
= 2.7 to 3.0 V
Note 6: V
IN
=0.8 to 2.0 V , V
CC
= 3.0 V
2015-01-30
Rev.3.0
