FTLF8519F2xCL 2x5 Pin SFF Product Specification – April 2006
IV. Optical Characteristics (T
OP
= 0 to 70 °C, V
CC
= 3.0 to 3.6 Volts)
Parameter Symbol Min Typ Max Unit Ref.
Transmitter
Output Opt. Pwr: 50 or 62.5 MMF P
OUT
-9 -3 dBm 1
Optical Wavelength
λ
830 860 nm
Spectral Width
σ
0.85 nm
Optical Modulation Amplitude OMA
Tx
196
μW
2
Optical Rise/Fall Time t
r
/ t
f
150 ps 3
Relative Intensity Noise RIN
-120 dB/Hz
Total Jitter Contribution (p-p)
TX
TJ
119 ps 4
Extinction Ratio @ 1.25 Gb/s ER 9 dB
Receiver
Receiver Sensitivity = 1.0625 Gb/s Rx
SENS
-20 dBm 5
Receiver Sensitivity = 2.125 Gb/s Rx
SENS
-18 dBm 5
Receiver Sensitivity = 1.25 Gb/s Rx
SENS
-20 dBm 6
Stressed RX sens. = 1.0625 Gb/s 0.055 mW 7
Stressed RX sens. = 2.125 Gb/s
0.096 mW 7
Stressed RX sens = 1.25 Gb/s -13.5 dBm 8
Average Received Power Rx
MAX
0 dBm
Receiver Elec. 3 dB cutoff freq. 1500 MHz
Optical Center Wavelength
λ
C
770 860 nm
Return Loss RL
12 dB
Signal Detect Normal SD
normal
-20 dBm
Signal Detect Fault SD
fault
-30 dBm
Signal Detect Hysteresis
0.5 dB
Notes:
1. Class 1 Laser Safety per FDA/CDRH, EN (IEC) 60825 laser safety regulations.
2. Equivalent extinction ratio specification for Fibre Channel. Allows smaller ER at higher average
power.
3. Unfiltered, 20-80%. Complies with FC 1x and 2x eye mask when filtered.
4. If measured with TJ-free data input signal. In actual application, output TJ will be given by:
()()
22
DJTJDJTJDJDJTJ
INININOUT
Δ−Δ+−+Δ+=
5. Specifications are for 50 micro-meter or 62.5 micro-meter fiber
6. As measured with 9dB extinction ratio.
7. Measured with conformance signals defined in FC-PI-2 10.0 specifications.
8. Measured with conformance signals defined in IEEE 802.3 specifications.
© Finisar Corporation April 7, 2006 Rev G Page 4