7
It is recommended that the PCB traces for the ground pins
NOT be connected together under neath the body of the
package. PCB pads hidden under the package cannot be
adequately inspected for SMT solder quality.
FR-4 or G-10 PCB material is a good choice for most low
cost wireless applications. Typical board thickness is 0.025
or 0.031inches. The width of 50 Ω microstriplines in these
PCB thicknesses is also convenient for mounting chip
components such as the series inductor at the input for
impedance matching or for DC blocking capacitors. For
noise gure sensitive applica tions, the use of PTFE/glass
dielectric materials may be warranted to minimize trans-
mis sion line losses at the ampli er input.
Higher Bias Voltages
While the MGA-87563 is designed for use in +3 volt bat-
tery powered applications, the internal bias regulation
circuitry allows it to be easily operated with any power
supply voltage from +2.7 to 5volts. Figure 15 shows an
increase of approximately 1 dB in the associated gain with
+5 volts applied. The P
1dB
output power (Figure 17) is also
higher by about 1 dBm. The e ect of higher V
dd
on noise
gure is negligible as indicated in Figure 16.
ASSOCIATED GAIN (dB)
0.5
9
FREQUENCY (GHz)
2.0
17
10
4.0
14
2.5
1.0
13
16
12
1.5 3.0 3.5
15
11
Figure 15. Associated Gain vs. Frequency at V
dd
= 5V.
OPTIMUM NF (dB)
0.5
0.5
FREQUENCY (GHz)
2.0
3.5
1.0
4.0
2.5
2.5
1.0
2.0
3.0
1.5 3.0 3.5
1.5
Figure 16. Optimum Noise Figure vs. Frequency at V
dd
= 5V.
P 1 dB (dBm)
0.6
-2.00
FREQUENCY (GHz)
0.00
-1.50
2.41.2
-1.00
-0.50
1.8 3.0 3.6 4.2
Figure 17. Output Power at 1 dB Gain Compression
vs. Frequency at V
dd
= 5V.