I-2 APEM www.apem.com
I
VL series
Professional LED indicators
Distinctive features and specifications
MATERIALS
• Bushing and collar : brass, bright
or matt black chrome plated
• Lens : polycarbonate
• LED
ELECTRICAL SPECIFICATIONS
• Insulation resistance : 1.000 MΩ min.
• Dielectric strength : 250 Vrms 50 Hz min.
• Electrical life at high temperature : 72 H at 85°C
LED specifications (T
A 25°C)
• Forward voltage : 2VDC (≤ 2,6V)
• Nominal current : 10mA
• Max. surge current (tp < 10µs) : 0,5A
• Max. reversed voltage : 25V
• Max. forward current : 40mA
• Max. power dissipation : 100mW
• Correct polarity of D.C supply to diode electrodes must be observed :
- longer lead : anode (+)
- shorter lead : cathode (-) on flat side of bushing (see drawings).
• The LED is not removable.
GENERAL SPECIFICATIONS
• Torque : 1,25 Nm (.922 Ft.lb)
max. applied to nut
• Climatic category : 40/085/21
• Protection level for sealed models:
IP 67 according to IEC 529
• In accordance with NFC 93680
standard
Mounting accessories : standard hardware supplied with all models : nickel plated hex nut 9 mm (.354) across flats for
indicators Ø 6 (.236) or 10 mm (.393) across flats for indicators Ø 8 (.314).
Packaging unit : 50 pieces.
Dimensions : first dimensions are in mm while inches are shown as bracketted numbers.
❑ Indicators with red, yellow or green built-in LED
❑ Antirotation flatted bushing
❑ 2 bushing diameters : 6 mm (.236) and 8 mm (.314)
❑ Sealed or unsealed
❑ Bright or matt black chrome finish
ABOUT THIS SERIES
Complete part numbers are shown on the following pages.
PANEL CUT-OUT
For Ø 6 (.236) For Ø 8 (.314)
STANDARD HARDWARE
For Ø 6 (.236) For Ø 8 (.314)
