MIC5216
500mA-Peak Output LDO Regulator
MM8 and Micrel Mini 8 are trademarks of Micrel, Inc.
Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1 (
408
) 944-0800 • fax + 1 (408) 474-1000 • http://www.micrel.com
March 2007
M9999-032307
General Description
The MIC5216 is an efficient linear voltage regulator with
high peak output current capability, very low dropout
voltage, and better than 1% output voltage accuracy.
Dropout is typically 10mV at light loads and less than
500mV at full load.
The MIC5216 is designed to provide a peak output current
for startup conditions where higher inrush current is
demanded. It features a 500mA peak output rating.
Continuous output current is limited only by package and
layout.
The MIC5216 has an internal undervoltage monitor with a
flag output. It also can be enabled or shutdown by a
CMOS or TTL compatible signal. When disabled, power
consumption drops nearly to zero. Dropout ground current
is minimized to help prolong battery life. Other key features
include reversed-battery protection, current limiting,
overtemperature shutdown, and low noise performance.
The MIC5216 is available in fixed output voltages in
space-saving SOT-23-5 and MM8™ 8-pin power MSOP
packages. For higher power requirements see the
MIC5209 or MIC5237.
Data sheets and support documentation can be found on
Micrel’s web site at www.micrel.com.
Features
Error Flag indicates undervoltage fault
Guaranteed 500mA-peak output over the full operating
temperature range
Low 500mV maximum dropout voltage at full load
Extremely tight load and line regulation
Tiny SOT-23-5 and MM8™ power MSOP-8 package
Low-noise output
Low temperature coefficient
Current and thermal limiting
Reversed input polarity protection
CMOS/TTL-compatible enable/shutdown control
Near-zero shutdown current
Applications
Laptop, notebook, and palmtop computers
Cellular telephones and battery-powered equipment
Consumer and personal electronics
PC Card V
CC
and V
PP
regulation and switching
SMPS post-regulator/dc-to-dc modules
High-efficiency linear power supplies
Typical Application
5V Low-Noise Regulator
3.3V Low-Noise Regulator
Micrel, Inc. MIC5216
March 2007
2
M9999-032307
Ordering Information
Part Number
Standard Marking Pb-Free Marking
Voltage
Junction
Temp. Range
Package
MIC5216-2.5BMM MIC5216-2.5YMM 2.5V –40° to +125°C 8-Pin MSOP
MIC5216-3.3BMM MIC5216-3.3YMM 3.3V –40° to +125°C 8-Pin MSOP
MIC5216-5.0BMM MIC5216-5.0YMM 5.0V –40° to +125°C 8-Pin MSOP
MIC5216-2.5BM5 LH25 MIC5216-2.5YM5 LH25 2.5V –40° to +125°C 5-Pin SOT-23
MIC5216-3.3BM5 LH33 MIC5216-3.3YM5 LH33 3.3V –40° to +125°C 5-Pin SOT-23
MIC5216-3.6BM5 LH36 MIC5216-3.6YM5 LH36 3.6V –40° to +125°C 5-Pin SOT-23
MIC5216-5.0BM5 LH50 MIC5216-5.0YM5 LH50 5.0V –40° to +125°C 5-Pin SOT-23
Micrel, Inc. MIC5216
March 2007
3
M9999-032307
Pin Configuration
MIC5216-xxBMM/YMM
MM8™ MSOP-8
Fixed Voltages
MIC5216-xxBM5/YM5
SOT-23-5
Fixed Voltages
Pin Description
Pin Number
MSOP-8
Pin Number
SOT-23-5
Pin Name Pin Function
2 1 IN Supply Input
5–8 2 GND Ground: MSOP-8 pins 5 through 8 are internally connected.
3 5 OUT Regulator Output
1 3 EN
Enable (Input): CMOS compatible control input. Logic high = enable; logic
low or open = shutdown.
4 4 FLG
Error Flag (Output): Open-Collector output. Active low indicates an output
undervoltage condition.

MIC5216BMM

Mfr. #:
Manufacturer:
Description:
IC REG LIN POS ADJ 500MA 8MSOP
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union