CUSTOMER DRAWING
SOLDERSLEEVE DEVICE WITH
PRE-INSTALLED LEAD, IMMERSION RESISTANT
Unless otherwise specified dimensions are in millimeters.
[Inches dimensions are shown in brackets]
Tyco Electronics reserves the right to amend
this drawing at any time. Users should evaluate
the suitability of the product for their
application.
© 2005-2017 TE Connectivity Corporation. All rights reserved. SolderSleeve is a trademark of Tyco Electronics Corporation
If this document is printed it becomes uncontrolled. Check for the latest revision.
MATERIALS
1. INSULATION SLEEVE: Heat-shrinkable, transparent blue, radiation cross-linked modified polyvinylidene fluoride. Marked
per table.
2. SOLDER PREFORM WITH FLUX AND THERMAL INDICATOR RING:
SOLDER: TYPE Sn63 per ANSI / J-STD-006.
FLUX: TYPE ROL1 per ANSI / J STD-004.
TERMAL INDICATOR RING: Fusible alloy with melt point of 221°C.
3. MELTABLE RINGS: Environment resistant fluorocarbon-based thermoplastic
4. PRE-INSTALLED LEAD: Raychem 55PC6121-GA. “GA”=size (AWG) of lead, color: white with 2 black stripes.
APPLICATION
1. These parts are designed to provide an environment resistant shield termination on cables, rated for 125C min. having tin or
silver-plated shields, and jackets compatible with the insert material. See M83519/2 or consult TE Connectivity.
2. When properly installed, these parts will meet the performance requirements of Raychem RT-1404 and SAE-AS-83519/2.
3. Part selection: Measure cable jacket diameter at its maximum point. Select the smallest terminator that has a “B” diameter
larger than the cable diameter.
4. Cable is to be stripped to expose 6.0 -7.5mm [0.235-0.295] of shield.
5. Part may be installed using any Raychem approved convection or infra-red heating tool. Tools must be equipped with a
suitable reflector. For detailed assembly instruction see Raychem RCPS-100-70.
