3
IDT74FCT38072
3.3V CMOS 1-TO-2 CLOCK DRIVER
INDUSTRIAL TEMPERATURE RANGE
DC ELECTRICAL CHARACTERISTICS OVER OPERATING RANGE
Following Conditions Apply Unless Otherwise Specified
Industrial: TA = -40°C to +85°C, VCC = 3.3V ± 0.3V
Symbol Parameter Test Conditions
(1)
Min. Typ.
(2)
Max. Unit
VIH Input HIGH Level 2 — 5.5 V
VIL Input LOW Level –0.5 — 0.8 V
IIH Input HIGH Current VCC = Max. VI = 5.5V — — ±1µA
IIL Input LOW Current VCC = Max. VI = GND — — ±1
VIK Clamp Diode Voltage VCC = Min., IIN = –18mA — –0.7 –1.2 V
IODH Output HIGH Current VCC = 3.3V, VIN = VIH or VIL, VO = 1.5V
(3,4)
–45 –75 –180 mA
IODL Output LOW Current VCC = 3.3V, VIN = VIH or VIL, VO = 1.5V
(3,4)
50 92 200 mA
IOS Short Circuit Current VCC = Max., VO = GND
(3,4)
–60 –135 –240 mA
V
OH Output HIGH Voltage VCC = Min. IOH = –12mA 2.4
(5)
3—V
VIN = VIH or VIL IOH = –100µAVCC - 0.2 — —
VOL Output LOW Voltage VCC = Min. IOL = 12mA — 0.3 0.5 V
VIN = VIH or VIL IOL = 100µA — — 0.2
NOTES:
1. For conditions shown as Max. or Min., use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at VCC = 3.3, 25°C ambient.
3. This parameter is guaranteed but not tested.
4. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.
5. VOH = VCC - 0.6V at rated current.
NOTES:
1. See test circuits and waveforms.
2. Minimum limits are guaranteed but not tested on Propagation Delays.
3. tPLH, tPHL, tSK(P), and tSK(O) are production tested. All other parameters guaranteed but not production tested.
4. Propagation delay range indicated by Min. and Max. limit is due to VCC, operating temperature and process parameters. These propagation delay limits do not imply skew.
5. Skew measured between all outputs under identical transitions and load conditions.
6. Skew measured is difference between propagation delay times tPHL and tPLH of same output under identical load conditions.
7. Part to part skew for all outputs given identical transitions and load conditions at identical VCC levels and temperature.
8. Airflow of 1m/s is recommended for frequencies above 133MHz.
SWITCHING CHARACTERISTICS OVER OPERATING RANGE
(3,4)
Symbol Parameter Conditions
(1,8)
Min.
(2)
Max. Unit
tPLH Propagation Delay CL = 15pF 0.5 3 ns
tPHL f ≤ 166MHz
tR Output Rise Time (0.8V to 2V) — 1 ns
tF Output Fall Time (2V to 0.8V) — 1 ns
tSK(O) Same device output pin-to-pin skew
(5)
— 100 ps
tSK(P) Pulse skew
(6)
— 350 ps
tSK(PP) Part to part skew
(7)
— 550 ps
f
MAX Input Frequency — 166 MH z
