6
LTC1380/LTC1393
PIN FUNCTIONS
UUU
S0 to S7/S0
±
to S3
±
(Pin 1 to Pin 8): Single-Ended Analog
Multiplexer Inputs (S0 to S7) for the LTC1380. Differential
Analog Multiplexer Inputs (S0
±
to S3
±
) for the LTC1393.
D
O
/D
O
+
(Pin 9): Analog Multiplexer Output for the LTC1380.
Positive Differential Analog Multiplexer Output for the
LTC1393.
V
EE
/D
O
–
(Pin 10): Negative Supply Pin for the LTC1380.
Negative Differential Multiplexer Output for the LTC1393.
For the LTC1380, V
EE
should be bypassed to GND with a
0.1µF ceramic capacitor when operating from split sup-
plies or connected to GND for single supply operation.
GND (Pin 11): Ground Pin.
A1, AO (Pin 12, Pin 13): Address Selection Pins. Tie these
two pins to either V
CC
or GND to select one of four possible
addresses to which the LTC1380/LTC1393 will respond.
SDA (Pin 14): SMBus Bidirectional Digital Input/Output
Pin. This pin has an open-drain output and requires a pull-
up resistor or current source to the positive supply for
normal operation. Data is shifted into and acknowledged
by the LTC1380/LTC1393 using this pin.
SCL (Pin 15): SMBus Clock Input. SDA data is shifted in
at rising edges of this clock during data transfer.
V
CC
(Pin 16): Positive Supply Pin. This pin should be
bypassed to GND with a 0.1µF ceramic capacitor.
BLOCK DIAGRA
W
ADDRESS
COMPARATOR
SMBus STATE
MACHINE
4-BIT LATCH
AND DECODER
SHIFT REGISTER
HOLD
STOP
1380/93 BD
SDA
A0
A1
SCL
MULTIPLEXER
SWITCHES
ANALOG OUTPUT(S)
(LTC1380: D
O
)
(LTC1393: D
O
±
)
ANALOG INPUTS
(LTC1380: S0 TO S7)
(LTC1393: S0
±
TO S3
±
)