EVERLIGHT ELECTRONICS CO., LTD.
Technical Data Sheet
Side View LEDs (Height 0.6mm)
99-216UMC/XXXXXXX/TR8
Everlight Electronics Co., Ltd. http://www.everlight.com Rev.1 Page: 15 of 15
Device No. : DSE-996-045 Prepared date: 24-Apr-2008 Prepared by: Giles Ni
4. Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds within
once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do
soldering of each terminal. Be careful because the damage of the product is often started at the time
of the hand solder.
5. Repairing
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a
double-head soldering iron should be used (as below figure). It should be confirmed beforehand
whether the characteristics of the LEDs will or will not be damaged by repairing.
6. Handling Indications
During processing, mechanical stress on the surface should be minimized as much as possible. Sharp
objects of all types should not be used to pierce the sealing compound
EVERLIGHT ELECTRONICS CO., LTD. Tel: 886-2-2267-2000, 2267-9936
Office: No 25, Lane 76, Sec 3, Chung Yang Rd, Fax: 886-2267-6244, 2267-6189, 2267-6306
Tucheng, Taipei 236, Taiwan, R.O.C http://www.everlight.com