Broadcom Condential
- 7 -
ACFL-6211T, ACFL-6212T Data Sheet
Package Characteristics
All Typical at T
A
= 25°C.
Parameter Symbol Min. Typ. Max. Unit Test Conditions Notes
Input-Output Momentary
Withstand Voltage
V
ISO
5000 V
RMS
RH ≤ 50%, t = 1 min.
T
A
= 25°C
6, 7
Input-Output Resistance R
I-O
10
14
W V
I-O
= 500V
dc
6
Input-Output Capacitance C
I-O
0.6 pF f = 1 MHz, T
A
= 25°C 6
Notes:
1. t
PHL
propagation delay is measured from the 50% (V
IN
or I
F
) on the rising edge of the input pulse to the 0.8V of V
DD
of the falling edge of the V
O
signal. t
PLH
propagation delay is measured from the 50% (V
IN
or I
F
) on the falling edge of the input pulse to the 80% level of the rising edge of the V
O
signal.
2. PWD is dened as |t
PHL
- t
PLH
|.
3. t
PSK
is equal to the magnitude of the worst case dierence in t
PHL
and/or t
PLH
that will be seen between units at any given temperature within the recommended
operating conditions.
4. CM
H
is the maximum tolerable rate of rise of the common mode voltage to assure that the output will remain in a high logic state.
5. CM
L
is the maximum tolerable rate of fall of the common mode voltage to assure that the output will remain in a low logic state.
6. Device considered a two terminal device: pins 1 to 6 shorted together, and pins 7 to 12 shorted together.
7. In accordance with UL 1577, each optocoupler is proof tested by applying an insulation test voltage > 6000V
RMS
for 1 second.
