2
PI5V330A
Low On-Resistance Wideband/Video
Quad 2-Channel Mux/DeMux
PS8695B 03/01/05
Storage Temperature ..........................................................–65°C to +150°C
Ambient Temperature with Power Applied .........................–40°C to +85°C
Supply Voltage to Ground Potential (Inputs & V
CC
Only)...–0.5V to +7.0V
Supply Voltage to Ground Potential (Outputs & D/O Only) –0.5V to +7.0V
DC Input Voltage ..................................................................–0.5V to +7.0V
DC Output Current.............................................................................120mA
Power Dissipation .................................................................................0.5W
Note:
Stresses greater than those listed under MAXIMUM RAT-
INGS may cause permanent damage to the device. This is
a stress rating only and functional operation of the device
at these or any other conditions above those indicated in the
operational sections of this specication is not implied. Ex-
posure to absolute maximum rating conditions for extended
periods may affect reliability.
Notes:
1. For Max. or Min. conditions, use appropriate value specied under Electrical Characteristics for the applicable device type.
2. Typical values are at V
CC
= 5.0V, TA = 25°C ambient and maximum loading.
3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.
4. Measured by the voltage drop between S1, S2, and D I/O pins at indicated current through the switch. On-Resistance is determined by the
lower of the voltages on the S1, S2, and D I/O pins.
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
DC Electrical Characteristics (Over the Operating Range, T
A
= –40°C to +85°C, V
CC
= 5V ±5%)
Parameters Description Test Conditions
(1)
Min. Typ.
(2)
Max. Units
V
ANALOG
Analog Signal Range 0 2.0
V
V
IH
Input HIGH Voltage Guaranteed Logic HIGH level 2.0
V
IL
Input LOW Voltage Guaranteed Logic LOW Level -0.5 0.8
I
IH
Input HIGH Current V
CC
= Max., V
IN
= V
CC
±1
µA
I
IL
Input LOW Current V
CC
= Max., V
IN
= GND ±1
I
O
Analog Output
Leakage Currnet
0 ≤ S1, S2, or D ≤ V
CC
, Switch OFF ±1
V
IK
Clamp Diode Voltage V
CC
= Min., I
IN
= -18mA -0.7 -1.2 V
I
OS
Short Circuit Current
(3)
150 mA
V
H
Input Hysteresis at
Control Pins
V
CC
= MIN., V
IN
= 1.0V R
L
= 75Ω, I
ON
= 13 mA 3 7 mV
R
ON
Switch On-Resistance V
CC
= MIN., V
IN
= 2.0V R
L
= 75Ω, I
ON
= 26 mA 3 7 10 Ω
