Reference only
ETP1M101
16 / 18
7. Taping specification
7-1. Dimension of capacitors on tape
Inside crimp taping type < Lead code : M1 >
Pitch of component 12.7mm / Lead spacing 5.0mm
Unit : mm
Item Code Dimensions Remarks
Pitch of component
P 12.7+/-1.0
Pitch of sprocket hole
P0 12.7+/-0.2
Lead spacing
F 5.0+0.6/-0.2
Length from hole center to component center
P2 6.35+/-1.3
Deviation of progress direction
Length from hole center to lead
P1 3.85+/-0.7
Deviation along tape, left or right defect
S 0+/-2.0
They include deviation by lead bend .
Carrier tape width
W 18.0+/-0.5
Position of sprocket hole
W1 9.0+0/-0.5
Deviation of tape width direction
Lead distance between reference and bottom
plane
H0 16.0+/-0.5
Protrusion length
0.5 max.
Diameter of sprocket hole
D0 4.0+/-0.1
Lead diameter
d 0.50+/-0.05
Total tape thickness
t1 0.6+/-0.3
They include hold down tape thickness.
Total thickness of tape and lead wire
t2 1.5 max.
Deviation across tape
h1
2.0 max.（Dimension code：W）
1.0 max.（except as above）
h2
Portion to cut in case of defect
L 11.0+0/-1.0
Hold down tape width
W0 9.5 min.
Hold down tape position
W2 1.5+/-1.5
Coating extension on lead
e
Up to the end of crimp
P2
P
P1
P0
L
D0
H0
W0
W1
W
0
h1
h2
S
t1
t2
Marking
W2
F
e
d
