Step 1 Slide heat shrink tubing and outer ferrule onto cable. Strip
cable jacket, braid and dielectric to dimensions shown in
table above. All cuts are to be sharp and square. Do not nick
braid, dielectric or center conductor when cutting. Tin center
conductor. Avoid excessive heat to prevent swelling of cable
dielectric. Flare end of cable braid slightly as shown to facilitate
insertion of inner ferrule. Do not comb out braid.
Step 2 Slide clamp nut over inner ferrule, and slide inner ferrule
under braid until cable dielectric is flush with front of inner
ferrule. Slide outer ferrule in place and crimp with die set
shown in table above.
Step 3 Place insulator washer on cable center conductor and
bottom against inner ferrule body as shown. Contact must
butt firmly against insulator washer while soldering.
Step 4 Screw ferrule-contact assembly into body and tighten to
20-25 lbf.-in. torque. Slide heat shrink tubing over ferrule,
up against clamp nut and shrink by applying heat.
324
Amphenol Corporation Tel: 800-627-7100 www.amphenolrf.com
BRAID CRIMP-SOLDER CENTER CONTACT TYPES FOR FLEXIBLE CABLE
Amphenol Connector
Cable RG-/U
Strip Dimensions, inches (mm) Hex Cavity for
Die Set for
Number
Type
abc
Outer Ferrule Tool 227-944
901-9601-1SF SMA Plug 55,58,141,142,223,400 .620(15.7) .350(8.9) .120(3.0) .213(5.4) 227-1221-11 Cavity A
901-9601-3 SMA Plug 174,179,187,188,316 .620(15.7) .350(8.9) .120(3.0) .128(3.3) 227-1221-03 Cavity A
901-9601-3SF SMA Plug 174,179,187,188,316 .620(15.7) .350(8.9) .120(3.0) .128(3.3) 227-1221-03 Cavity A
901-9602-1, -1SF SMA Jack 55,58,141,142,223,400 .610(15.5) .340(8.6) .110(2.8) .213(5.4) 227-1221-11 Cavity A
901-9602-3, -3SF SMA Jack 174,179,187,188,316 .610(15.5) .340(8.6) .110(2.8) .128(3.3) 227-1221-03 Cavity A
901-9602-12SF SMA Jack Double Braid 316 .610(15.5) .340(8.6) .110(2.8) .128(3.3) 227-1221-03 Cavity A
901-9610-1SF SMA Bulkhead Jack 55,58,141,142,223,400 .610(15.5) .340(8.6) .110(2.8) .213(5.4) 227-1221-11 Cavity A
901-9610-3, -3SF SMA Bulkhead Jack 174,179,187,188,316 .610(15.5) .340(8.6) .110(2.8) .128(3.3) 227-1221-03 Cavity A
901-9610-12SF SMA Bulkhead Jack Double Braid 316 .610(15.5) .340(8.6) .110(2.8) .151(3.8) 227-1221-37 Cavity B
901-10015 SMA Bulkhead Jack LMR 240 4.93(12.5) — .043(2.4) .255(6.5) 227-1221-59 Cavity A
