PRODUCT SPECIFICATION
1.27mm PITCH SLIM-GRID
®
SHROUDED HEADERS
TEMPLATE FILENAME: PRODUCT_SPEC[SIZE_A4](V.2).DOC
6.0 APPLICATION
6.1 PLACEMENT FORCE - CONNECTOR 201021 SERIES
For series 201021 with peg option, it is recommended to apply a minimum force of 20N onto a
mounting gauge to ensure crushed pegs are properly inserted into PCB holes
6.2 MOUNTING WEIGHT - CONNECTOR 201021 SERIES
For series 201021 without peg option, it is recommended to place a weight (>2g) on connector to
minimize the lifting of light weight connector by surface tension of solder paste
6.3 PCBA ORIENTATION TO OVEN - CONNECTOR 201021/201022 THROUGH-HOLE SERIES
It is recommended to place the connector on board in the following orientation before send the PCBA
assembly to wave soldering oven.
7.0 PACKAGING
Parts shall be packaged to protect against damage during handling, transit and storage.
Parts are packaged in bulk, tape and reel or tube, refer to Appropriate Sales Drawing and Packaging
Specification for specific information.
8.0 OTHERS
8.1 Although some discolouration could be seen on the soldertail after reflow, it does not impact on the
product’s performance.
8.2 Mating should be performed as close as possible to the mating axis for the delicate ckt sizes.